&RQQHFWLQJWKH8QLWV
1RWH
? This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a
recreational vehicle, truck, or bus, check the battery voltage.
? To avoid shorts in the electrical system, be sure batt to diery cascoble bennectfore th bee ginning
installation.
? Refer to the owner's manual for details on connecting the power amp and other units, then make
connections correctly.
? Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
? Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and
seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of
the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.
? Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This
will damage the lead insulation and cause a very dangerous short.
? Do not shorten any leads. If you do, the protection circuit may fail to work when it should.
? Never feed power to other equipment by cutting the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.
? When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder.
? Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or
the left and r spigheat ker leads are common.
? Speakers connected to this unit must be high-power types with minimum rating of 45 W and
impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those
noted here may result in the speakers catching fire, emitting smoke or becoming damaged.
? When an external power amp is being used with this system, be sure not to connect the blue/white
lead to the amp's power terminal. Likewise, do not connect the blue/white lead to the power terminal
of the auto-antenna. Such connection could cause excessive current drain and malfunction.
? To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side
is black. Connect the connectors of the same colors correctly.
? If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition
switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/
OFF operations. If this is not done, the vehicle battery may be drained when you are away from the
vehicle for several hours.
ACCOO
FFNFFN
OSOS
TT
AA
RR
TT
ACC positionNo ACC position
? The black lead is ground. Please ground this lead separately from the ground of high-current products
such as power amps.
If you ground the products together and the ground becomes detached, there is a risk of damage to the
products or fire.
CAUTION
? Cords for this product and those for other products may be different colors even if they have
the same function. When connecting this product to another product, refer to the supplied
Installation manuals of both products and connect cords that have the same function. |
ACEC
PIONEER
