DOLBY SURROUND AND DTS SURROUND
This unit is equipped with the Dolby Pro Logic decoder4Press SURROUND., Dolby
Digital decoder and DTS decoder.Pressing the button changes the surround mode according to
The unit and the centre and surround speakers (standard) assurethe type of the input signal, as follows.
full-scale home theatre sound. When playing back discs or video
software that have been recorded in Dolby Pro Logic, Dolby DigitalIn case Dolby Digital or DTS multichannel source is input:
surround or DTS surround, astonishingly realistic sound
DOLBY D or DTS2chSTEREO
surrounds the listener to create a new level of audio/visual
entertainment.
In case Dolby Digital 2-channel source or other source is input:
Independent control of the five channels allows the listener to
Select Dolby Pro Logic or 2chSTEREO first by pressing
enjoy the same type of sound reproduction experienced in movie
SURROUND. Then, turn MULTI JOG to select the desiredSURROUND
theatres. Voices are reproduced in the front and centre sound
Pro Logic mode.
field, while ambient sounds like cars and crowds are reproduced
on all sides of the listener for an incredibly lifelike audio/videoPLII CINEMA
experience.
DOLBY SURROUND AND DTS
PLII MUSIC2chSTEREO
PRO LOGIC
TURNING SURROUND ON AND
The following indicators light according to the input signal and
other conditions.
OFF
h
: Dolby Digital signal is input.
!" : DTS source signal is input.
h
# II$ : 2-channel source is played with surround
INPUT
set to on.
MODE
SURROUND
SURROUNDIf you feel that the surround effect is not sufficient
Surround playback is affected by many factors. Check the
following points.
YAre settings made correctly according to the connected
speakers and their position?
YIs the DVD digital out signal correctly selected?
YIn Dolby Digital and DTS, there are multi-sources other than
5.1ch. Confirm the type of the source being played.
FUNCTIONYA disc may contain multiple audio tracks. Confirm the audio
INPUT MODEtrack being played.En
YDolby Digital and DTS sources can be enjoyed only when
connections are made in digital.
Check the followings:NOTE
YBefore enjoying Dolby surround or DTS surround, set theYThis unit supports input signals of the Dolby Digital surround
speaker existance, size and distance (see page 16), andbit stream, DTS surround bit stream and linear PCM whose
adjust the speaker sound levels to the proper balance (seesampling frequency is 32 kHz, 44.1 kHz, 48 kHz and 96 kHz.
page 17).YWhen connecting some DVD players to the receiver through
YMake sure the speakers are properly connected and positionedthe digital in terminals, noise may be heard in the DVD operation:
(see pages 6 and 7).e.g. searching a disc, skipping a chapter, entering a menu
YMake sure the TV set and video unit are properly connectedscreen.
(see page 4).
YMake sure the disc and video tape, etc., support Dolby Pro
Logic, Dolby Digital surround or DTS surround.
YWhen connecting an LD player equipped with the AC-3 RF OUT
terminal, use an RF demodulator unit. Also connect the
analogue AUDIO OUT terminals of the LD player to the receiver
to play all the sources. For further information, refer to the
instructions of the LD player.
1Turn FUNCTION to select a function (except 5.1ch
IN).
2 Press INPUT MODE repeatedly to select "
"
or "
".
Select in accordance with the connected equipment and sound
source to be played.
3Play the surround source by the connected
equipment.
ENGLISH 15 |
ACEC
AIWA
