If a fault occurs, run through the table below before taking your unit for repair.
If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation, consult
your dealer. Under no circumstances should you repair the unit yourself as this will invalidate the warranty!
PROBLEMPOSSIBLE CAUSEREMEDY
No powerThe AC input cord is disconnected.Connect cord securely.
ENGLISH
Poor connection at AC wall outlet or theCheck the outlet using a lamp or another
outlet is inactive.appliance.
No soundThe speaker cords are disconnected.Check the speaker connections on the power
amplifier.
The master volume is adjusted too low.Adjust the master volume.
The MUTE button is pressed to ON.Press the MUTE button to cancel the muting
effect.
The digital input is not selected correctlySelect the digital input correctly.
Incorrect selection of input source.Select the desired input source correctly.
Incorrect connections between theMake connections correctly.
components.
No sound from the rear speakersSurround mode is switched off.(normal stereoSelect a surround mode.
mode)
Master volume and rear level are too low.Adjust master volume and rear level.
Monaural source is used.Select a stereo or surround source.
Dolby 3 Stereo mode is selected.Select the desired surround mode.
No sound from the centerDTS,Dolby Digital, Dolby Pro Logic orSelect the desired surround mode.
speakerDolby 3 Stereo mode is not selected.
Master volume and center level are too low.Adjust master volume and center level.
Stations cannot be receivedNo antenna is connected.Connect an antenna.
The desired station frequency is not tuned in.Tune in the desired station frequency.
Antenna is in wrong position.Move antenna and retry tuning.
Preset stations cannot beAn incorrect station frequency has beenMemorize the correct station frequency.
memorized.
received
The memorized stations are cleared.Memorize the stations again.
Poor FM receptionNo antenna is connected. Connect an antenna.
The antenna is not positioned for the bestChange the position of the antenna.
reception.
Continuous hissing noise duringWeak signals.Change the position of the antenna.
FM reception, especially when aInstall an outdoor FM antenna.
stereo broadcast is received.
Continuous or intermittentNoise is caused by motors, fluorescent lampsKeep the receiver away from noise sources.
hissing noise during AMor lightning, etc.Install an outdoor AM antenna.
reception, especially at night.
Remote control unit does notBatteries are not loaded or exhausted.Replace the batteries.
operate.The remote sensor is obstructed.Remove the obstacle.
Other Sherwood components doDIGI LINK connections are not madeMake proper DIGI LINK connections.
not react to remote controlproperly.
commands.
Clear it using To clear a video label? (Refer to
A video label cannot beMulfunction due to external influences such
displayed.as static electricity, etc.?Rectifying or clearing a video label? on page
28)
OSD function cannot beVideo connections between this unit and theMake proper video connections.
availabe.monitor TV are not made correctly.
35 |
ACEC
SHERWOOD
