ENGLISH
Check of the measurement results Setting the type of speakers
Y Set up in function of your speaker systems. Performing this setup optimizes the system.
Select the items.
Y The composition of the signals output to the different channels and the frequency response are adjusted
1The measurement results of each item can be checked
automatically according to the combination of speakers actually being used.
here.
Set whether or not speakers are connected and, if so, their size parameters.
(Remote control unit)A.Set SpConf.Ck1
YTo select the speakerFront Sp. Center Sp. Front Sp.
Press the ENTER button and display the verification screen.Subwoofer
2(Remote control unit)Listening position
[Speaker Config. Check][Delay Time Check][Channel Level Check]
Surround Sp.
Surround Sp.
(Remote control unit)
Surround back Sp.
(Remote control unit)YTo select the parameter
2 FRONT LARGE
NOTE:
Y When measurements have been made using the measurement microphone,
speakers with a built-in filter such as subwoofers might be set with a value
Press the ENTER or (down) button to enter the settings and switch to the
that differs from the physical distance because of the internal electrical delay.2
SPEAKER DISTANCE setting.
If the check ends, press the ENTER button again.
3(Remote control unit)
Y Parameters
(Remote control unit)Large.................Select this when using speakers that have sufficient performance for reproducing bass sound
below the frequency set for the Crossover Frequency mode.
Small.................Select this when using speakers that do not have sufficient performance for reproducing bass
Select from the following three items based on the
4measurement results.sound below the frequency set for the Crossover Frequency mode. When this is set, bass
sound with a frequency below the frequency set for the Crossover Frequency mode is sent
YStore : Set with the checked measurement
to the subwoofer.
value.
None.................Select this when no speakers are installed.
Y Retry : Perform the measurement again.
(Remote control unit)Y Cancel : Cancel the checked measurementYes/No...............Select OYes� when a subwoofer is installed, ONo� when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
value.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
A.Set <StoreOSmall� is set for the front, center and surround speakers.
When the OStore� is selected, all parameters are
5stored up and switch to the SUBWOOFER MODE
setting.
(Remote control unit)
14 |