AVR125 harman/kardon
INSTALLATION AND CONNECTIONS
should be connected to the Video 1 Out JacksPower Connections
bk31 on the AVR 125.This unit is equipped with two accessory AC outlets.
They may be used to power accessory devices, but
2. Connect the analog audio and video outputs of athey should not be used with high-current draw equip-
television set or any other video source to the Video 2ment such as power amplifiers. The total power draw
Jacks d3233 .to each outlet may not exceed 100 watts.
3. Connect the analog audio and video outputs of aThe Switched AC Accessory Outlet ¤ will receive
cable TV converter or satellite receiver, or any otherpower only when the unit is on. This is recommended
video source, to the Video 3 Jacks %^ on thefor devices that have no power switch or a mechanical
front panel of the AVR 125.power switch that may be left in the OON� position.
4. Connect the analog audio and video outputs of NOTE: Many audio and video products go into a
a DVD or laser disc player to the DVD JacksStandby mode when they are used with switched out-
gh. When a digital audio connection is usedlets, and cannot be fully turned on using the outlet
for your DVD player, the default connection is thealone without a remote control command.
Coaxial Digital Input 1 Jack ?. However, the
connection may also be made to any of the OpticalThe Unswitched AC Accessory Outlet ? will
c# or Coaxial ?$ Digital Inputs, providedreceive power as long as the unit is plugged into a
that the digital input source selection is changed aspowered AC outlet.
shown on page 23. If your DVD or DVD-Audio player
Finally, when all connections are complete, plug the
includes an onboard surround decoder and 6-channelPower Cord ? into a nonswitched 120-volt AC wall
line-level audio outputs, you may connect these audio
outputs to the 6-Channel Direct Inputs e. Whenoutlet. YouOre almost ready to enjoy the AVR 125!
you wish to hear this decoded audio, select the DVD
Input first in order to select the video signal from the
DVD player, then select the 6-Channel Direct Input
source for the audio.
5. Connect the digital audio outputs of a DVD player,
satellite receiver, cable box or HDTV converter to the
appropriate Optical or Coaxial Digital Inputs
c#$.
6. Connect the Video Monitor Output f jacks
on the receiver to the composite or S-Video input of
your television monitor or video projector.
VIDEO CONNECTION NOTE:
Y Composite and S-Video signals may only be viewed
in their native formats. The AVR 125 will not convert
signals from composite to S-Video, or vice versa.
S-Video inputs may only be viewed when the
AVR 125 is connected to a TV set or video display
with S-Video capability. If you use both standard
composite video and S-Video sources in your
system, it is important that you connect both an
S-Video cable and a standard composite video
cable (a coax cable with an RCA plug on both
ends) between the AVR 125 and your TV or projec-
tor. When it is necessary to make both types of
connections to your TV set, use different inputs if
possible. Consult the instructions for your TV set or
projector for more information on connecting both
types of signals.
INSTALLATION AND CONNECTIONS 15
15 |
ACEC
HARMAN KARDON
