FM AntennaAM AntennaCD PLAYER
L R Optical Coax
430
Figure 4 � Audio Connections
REC/INDashed lines (����) indicate coaxial and optical
digital audio connections. Choose either type
(but not both) for each digital audio source.
PLAY/OUT
AUDIO RECORDER
Step 4. Connect AM and FM antennas (Fig. 4) (see page 16).reassigned. Connect the component, composite and S-Video Monitorspeaker choices for your system (see pages 23�25).
Step 5. Connect source components, as shown in Figures 4 and 5, and theoutputs to your Video Monitor (TV). Switch your TV setOs input toStep 9. Set the Output Levels with EzSet: Set the Volume to �15dB.
Device Connection Options chart on the back of this guide (seematch the type of video used for the currently selected source.Sit in the listening position and hold the remote in front of you at
pages 16�17).Step 6. Plug all components into AC power outlets. The outlets on the backshoulder level, pointing it at the AVR. Press the EzSet button on the
AUDIO connections: Right channel (red) on source to right (red) of the AVR 430 should be used only for low-current products, suchremote, and then the Set button when it lights red. Following the
on AVR, and left channel (white) on source to left (white) on AVR.as CD or DVD players, and the total should not exceed 100 watts.instructions in the remoteOs LCD display, press the button on the
DIGITAL AUDIO connections, if available: Choose either coaxialBasic Receiver Configurationremote until the display shows the number of speakers in your system
(orange) to coaxial (orange) OR optical to optical for each device.Step 7. Select digital inputs: If your DVD is connected to Coaxial 1, noand then press the Set button again. Hold the remote steady until the
The Coaxial 1 input defaults to the DVD player; however, it may beadjustment is needed. For any other digital-device connections, useLCD display flashes a COMPLETE message (see page 26).
reassigned. Assign the other digital inputs and outputs as appropriatethe front-panel Digital Select button and the arrow buttons to selectStep 10. Your system is configured � sit back and enjoy!
for your equipment (see Step 7).an optical or coaxial digital input (see pages 21 and 32).
VIDEO connections: Choose component (Y/Pb/Pr � green/blue/Step 8. Configure speakers: No action is needed if you have five Osmall�
red), composite (yellow) or S-Video (4-pin) for each video source.satellite-type speakers and a subwoofer. Otherwise, press the Speaker
The Component Video 1 inputs default to the DVD player, but may bebutton and then the Set and arrow buttons to select the correct
SPEAKER AND AUDIO CONNECTIONS |
ACEC
HARMAN KARDON
