Remote Control Programming and Operation
All other keys may only be programmed1. Slide Use/Learna switch at theClearing the Remote Memory
with one remote code. The codetop left corner of the remote to the rightIn normal operation, codes for a new
contained in these keys remains theso that it is next to Learn.device may be programmed Oover� the
same regardless of the source selection.codes that have been previously pro-
2. If one of the multifunction buttons grammed into the remote. It is also pos-
WARNING: These keys transmit codesis being programmed press the sourcesible to clear the memory for individual
that are vital to the operation of thebutton (e.g. CD , VID1) you wish to keys, or for the entire remote. When a
product. It is not recommended that theyhave this function associated with. If youmemory position is cleared, the remote
be programmed with alternative codes,are programming a single function key,will return to the original factory preset
as it may then be impossible to operateproceed to the next step.command.
certain functions of the receiver.
Night 3. Press the button on the remote that isTo clear the memory for a specific indi-
to be programmed. Note that thevidual key location, put the Use/Learn
Delay
LearningLEDwill illuminate.switch in the Learnposition. Press the
RF Main Power Offcbutton and the
Opt4. Place the remote head to head with thebutton to be cleared at the same time.
Coaxremote control whose function is beingBoth the Sendingand Learningindi-
Select learned. The two remotes should be nocators will light momentarily. When the
more than 8 inches apart.lights go out, the memory has been
All Mode Selectors
cleared of the user programmed code
*5. Press and hold the button on theand returned to the factory preset. Return
#
remote corresponding to the function the Use/Learna switch to the Use
Displayto be memorized until the Learningposition when you are finished.
Speaker �ULED starts to blink. When the LED goes
CH Selectout, release the button on the transmit-To clear the remoteOs entire memory
ting remote. The function code has beenand return all keys to their factory preset
Volume �U
successfully captured by the remote.commands, first put the Use/Learna
Test Tone
switch in the Learnposition. Then press
Mute
NOTE: If both LEDs flash during a pro-the Main Power Onbutton c and
To program the remote, follow these steps.gramming operation, it indicates thatconfirm that the Learningindicator
Note that it is not necessary to programthe remoteOs memory is full or that thehas illuminated. While continuing
all keys, only those that are required toremote codes from the transmittingto press the Main Power Onbutton,
operate the subject device. Keys notremote are not compatible with the unitOspress and hold the Main Power Off
programmed will retain the codessignal format.cbutton until the Learnindicator
preprogrammed at the factory.goes off for about 3 seconds. It will then
6. Continue to program any additionalblink twice. Then release the two buttons.
remote commands required using stepsThis indicates that the memory has been
2 through 5. When you have finishedcleared of any user programmed com-
programming the remote, slide themands and that the original commands
Use/Learnswitchtotheleftsothatithave been restored. Slide the Use/Learn
is in theUse position.switch a back to the Use position to
return the remote to normal operation.
AVR55 120 volt |
ACEC
HARMAN KARDON
