AVR75 om (c) 9/16/98 11:33 AM Page 16
Remote Control Programming and Operation
16
All other keys may only be programmedare programming a single function key,To clear the memory for a specific indi-
with one remote code. The codeproceed to the next step.vidual key location, put the Use/Learn
contained in these keys remains theswitch in the Learnposition. Press the
same regardless of the source selection.3. Press the button on the remote that isMain Power Offcbutton and the
to be programmed. Note that thebutton to be cleared at the same time.
WARNING: These keys transmit codesLearning`LED will illuminate.Both the Sendingand Learningindi-
that are vital to the operation of thecators will light momentarily. When the
product. It is not recommended that they4. Place the remote head to head with thelights go out, the memory has been
be programmed with alternative codes,remote control whose function is beingcleared of the user programmed code
as it may then be impossible to operatelearned. The two remotes should be noand returned to the factory preset. Return
certain functions of the receiver.more than 8 inches apart.the Use/Learna switch to the Use
position when you are finished.
Night
5. Press and hold the button on the
Delay
remote corresponding to the function To clear the remoteOs entire memory
RF to be memorized until the Learningand return all keys to their factory preset
OptLED starts to blink. When the LED goescommands first put the Use/Learna
Coaxout, release the button on the transmit-switch in the Learnposition. Then press
Select ting remote. The function code has beenthe Main Power Onbutton c and
successfully captured by the remote.confirm that the Learningindicator
All Navigation Buttons ���U
`has illuminated. While continuing
All Mode Selectors
NOTE: If both LEDs flash during a pro-to press the Power Onbutton, press and
gramming operation, it indicates thathold the Power Offc button until the
*
#the remoteOs memory is full or that theLearnindicator goes off for about 3 sec-
Displayremote codes from the transmittingonds. It will then blink twice. Then
OSD remote are not compatible with the unitOsrelease the two buttons. This indicates
signal format.that the memory has been cleared of any
Speaker �U
user programmed commands and that
CH Select
6. Continue to program any additionalthe original commands have been
Volume �U
remote commands required using stepsrestored. Slide the Use/Learnswitch
Test Tone2 through 5. When you have finishedaback to the Use position to return
Muteprogramming the remote, slide thethe remote to normal operation.
Use/Learnswitchtotheleftsothatit
To program the remote, follow these steps.is in theUse position.
Note that it is not necessary to program
all keys, only those that are required to
Clearing the Remote Memory
operate the subject device. Keys not
In normal operation, codes for a new
programmed will retain the codes
device may be programmed Oover� the
preprogrammed at the factory.
codes that have been previously pro-
grammed into the remote. It is also pos-
1. Slide Use/Learna switch at the
sible to clear the memory for individual
top left corner of the remote to the right
keys, or for the entire remote. When a
so that it is next to Learn.
memory position is cleared, the remote
will return to the original factory preset
2. If one of the multifunction buttons command.
is being programmed press the source
button (e.g. CD , VID1) you wish to
have this function associated with. If you
AVR75 120 rev (c) 8/27/97 |
ACEC
HARMAN KARDON
