AEG_7480_ifu.qxp 2005.01.31. 15:44 Page 11
Remove the protector mesh byTroubleshooting
pulling it out.
Power: If the electric power does
Shake the dirt from the filter andnot come on, disconnect from
the mesh into a bin. If necessary,
mains and check plugs, cable and
the filter and mesh can be rinsed,
with cold water, under a tap .fuses where appropriate.
Air dry them for approximately 24Blockages/dirty filters: The cleaner
hours, to ensure it is completely drymay switch itself off in the event of
before re-using. Avoid direct sun-a severe blockage or excessively
light and extreme drying circum-dirty filter(s). In such cases, discon-
stances (hair-dryer, etc.). If you
wish to use your appliance whilenect from mains and allow to cool
for 20-30 minutes.Clear blockage
the cartridge filter is drying, you
may use the extra cartridge filterand/or replace filter(s) and restart.
inserted in the packaging boxThe clearing of blocked hoses is not
7480covered by the guarantee.
Insert the protector mesh back intoPlease also see AEG-Electrolux
additional information in the sepa-
its place by pulling it onto the car-rate AEG-Electrolux Warranty
tridge filter.
Booklet.
Insert the cartridge filter back intoWater: If water is sucked into the
the cartridge filter plate by turning
it clockwise.cleaner the motor must be changed
at an AEG-Electrolux Service
Insert the cartridge filter back into
the dust container cover (B) andCentre.
turn it clockwise (A).
Insert the dust container cover back
into the dust container (B) and turn
it clockwise (A).
Put the dust container back into
the cleaner.
Cartridge filter reference number:
440077 113355 665544//99..
Cleaning the exhaust filter:
Open the filter grill to remove the
exhaust filter.
Take the filter out of the grill and
insert a new one.
Close the filter grill.
Exhaust filter reference number:
MMeennaalluuxx DD0099..
11 |
ACEC
AEG
