132994650.qxd 6/25/02 10:19 AM Pagina 18 (Nero/Process Black pellicola)
When no more water comes out, unscrew the pumpClean the filter using a hard bristle brush.
cover and remove it. Always keep a cloth nearby toTighten up the inlet hose.
dry up spillage of water when removing the cover.
The dangers of freezing
?Remove any objects from the pump impeller by
If the machine is exposed to temperatures below 0°C,
rotating it.
certain precautions should be taken.
ITurn off the water tap.
IUnscrew the inlet hose.
IPlace the end of the emergency emptying hose and
that of the inlet hose in a bowl placed on the floor
and let water drain out.
IScrew the water inlet hose back on and reposition
the emergency emptying hose after having put the
cap on again.
Put the cap back on the emergency emptying hose and
I
place the latter back in its seat.When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
Important!
Every time you drain the water through the emergency
emptying hose you must pour 2 litres of water into the
main wash compartment of the detergent drawer and
then run the drain programme. This will activate the
ECO valve avoiding that part of the detergent remains
unused at next washing.
Screw the pump cover fully in.
Close the pump door.Emergency emptying out
If the water is not discharged, proceed as follows to
Warningempty out the machine:
When the appliance is in use and depending on the pull out the plug from the power socket;
programme selected there can be hot water in the pump.
close the water tap;
Never remove the pump cover during a wash cycle,
if necessary, wait until the water has cooled down;
always wait until the appliance has finished the cycle,
open the pump door;
and is empty. When replacing the cover, ensure it is
place a bowl on the floor and place the end of the
securely retightened so as to stop leaks and young
children being able to remove it.emergency emptying hose into the bowl. Remove its
cap. The water should drain by gravity into the bowl.
When the bowl is full, put the cap back on the hose.
Cleaning the water inlet filter
Empty the bowl. Repeat the procedure until water
If your water is very hard or contains traces of lime
stops flowing out;
deposit, the water inlet filter may become clogged.
clean the pump if necessary as previously described;
It is therefore a good idea to clean it from time to time.
replace the emergency emptying hose in its seat after
Turn off the water tap. Unscrew the water inlet hose. having plugged it;
screw the pump cover again and close the door.
18 |
ACEC
TRICITY BENDIX
