INSTALLATION INSTRUCTIONS
1) ELECTRICAL CONNECTIONS2.2 Non-polarized plugs (e.g. 2 pin with side
?Warning - this appliance must be earthed?earth contact)
This appliance is normally supplied with a mains The wire which is coloured GREEN AND
lead having a plug fitted in the factory which has YELLOW must be connected to the earth
been checked for correct earth continuity. contact. The other two wires should be
connected to the two pins, irrespective of colour.
If the fitted plug is not suitable for your socket
outlet, or if the machine?s mains lead is not fitted
with a plug, you should fit a suitable new, good 3) FUSE REPLACEMENT
quality plug by following the instructions in (2) If the mains lead of this appliance is fitted with a
below.BS 1363A 13 amp fused plug, replace the fuse
Any unsuitable plug should be cut off and only with an A.S.T.A. approved type conforming
disposed of in order to avoid a possible shock to BS 1362 and proceed as follows:
hazard should it be inserted into a socket.
2) CONNECTION TO A REWIRABLE PLUG - to be
carried out only by a qualified electrician
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - ?NEUTRAL? (?N?)
BROWN - ?LIVE? (?L?)
GREEN AND YELLOW - ?EARTH? (?E?)
To fit a new plug, proceed as follows:
2.1 Polarized Plugs (e.g. 3 pin, 13 amp plug
conforming to BS 1363A)
a. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is 1. Remove the fuse cover (A) and the fuse (B).
marked with the letter ?E? or by the Earth
symbol or coloured yellow or green and 2. Fit the replacement 13 A fuse into the fuse
yellow.cover.
b. The BLUE wire must be connected to the 3. Refit both into the plug.
terminal which is marked with the letter ?N? or For all other types of plug, the supply socket
coloured black.should be protected by a 16A fuse or circuit
c. The BROWN wire must be connected to the breaker at the distribution board.
terminal which is marked with the letter ?L? or
coloured red.
18 |
ACEC
WHIRLPOOL
