30105536aGB.fm Page 27 Thursday, December 30, 2004 10:53 AM
b.Draining faultd.Water Stop fault (if available)
Waste water not pumped out. The ?Water Stop? may have been triggered by:
In models with LCD display, the display shows:1. excess foaming
2. a leak in the washing machine
In this case the pump is switched on automatically
For models with a fault display, depending on the in order to drain the water
model, ?FP? lights up and remains lit or flashes. If a In models with LCD display, the display shows:
?Clean pump? indication is fitted, the red indication ?
next to it lights up.Water Stop Fault?
For models with no fault display, the washing For models with a fault display, the ?Water Stop?
machine stops in the appropriate programme step.indicator light lights up. The display shows ?FA? or
Stop the appliance and unplug it.alternately ?F? and ?A? and the pump is running.
Check whether:Switch off the appliance, unplug it and make sure
that the water tap is closed.
? kinks are present in the drain hose;Carefully tilt the appliance forwards to allow the
? the pump or the filter is blocked (see ?Removing
the filter?)water to flow out.
IMPORTANT: make sure the water has cooled Then:
before draining the appliance.1. Plug in the appliance.
2. Turn the water tap on (if water immediately
? the drain hose is frozen up
Plug in the appliance once again.flows into the appliance again, without the
Select and start the ?Drain/Reset? programme.appliance running, there is a fault. Shut the water
tap, then call After-Sales Service).
If the fault occurs again, please contact After Sales 3. Select and start the desired programme again.
Service (see ?After Sales Service?).
c. Fault in an electrical component
The appliance stops during the programme.
If a digital or LCD display is fitted, ?F4? to ?F31? are
also displayed.
Select and start the ?Drain? or ?Reset? programme.
Next, select and start the desired programme.
For models with no fault display, the washing
machine stops in the appropriate programme step.
Switch the washing machine off and back on again
to continue the programme.
If the fault persists, please contact After Sales
Service (see ?After Sales Service?).
27
Black process 45.0° 100.0 LPI |
ACEC
WHIRLPOOL
