Connections
+When using the control panel
YStandard connections
Lens zoom / focus cableMax. distance of 500 meters (when extended) between
pan/tilt head and pan-tilt control panel (monitor, G/L source)
ENG camera
Zoom lens
Color monitor
Video camera control cable
AW-CA16U10 (10 meters)
AW-CA16U20 (20 meters)Component signals
AW-CA16U30 (30 meters)
Video signals (5C-2V coaxial cable)
G/L signals
(5C-2V coaxial cable)
Pan/tilt head control cableModular joint connector10 BaseT straight cable
AW-PH500AW-CA24U10 (10 meters)(UTP category 5)
Pan/tilt head
AW-CA24U20 (20 meters)
for ENGAW-CA24U30 (30 meters)
applications
AW-RP301
O I
Pan-tilt control panel
AW-PS505
AC adapterAW-PS301
AC adapter
O I
AW-PS505
AC adapter
<Notes>
eIf two to five cameras and pan/tilt heads are to be connected, use the AW-RP305 as the controller, and connect the units
through the AW-HB505 multi-port hub. For details on the connections, refer to the operating instructions of the units
concerned.
eThe distance between the camera pan/tilt head and controller can be extended to 500 meters (maximum) using the
10 BaseT straight cable (UTP category 5).
eThe cable for outputting the video signals from the camera pan/tilt head and the cable for inputting the G/L signals to the
pan/tilt head can be extended to 500 meters (maximum) using the 5C-2V coaxial cable.
eProvide the cables listed below for the connections between the camera and pan/tilt head. Make the cables long enough to
support the connections when the camera is attached to the pan/tilt head and the pan/tilt head is moved upward and
downward.
(Approx. 60 cm: This length differs depending on the camera which is attached and the positions of the cameraOs
connectors.)
1 DC power cable (DC 12 V, 4-pin Cannon connector at pan/tilt head end)
2 Video output cable (composite video, BNC connector at pan/tilt head end)
3 G/L input cable (G/L signals, BNC connector at pan/tilt head end)
4 Component output cable (component signals: 9-pin D-sub connector at pan/tilt head end; used only when component
signals are to be output from a camera with component output connectors)
eWhen a motorized zoom lens is used, and its zoom/focus functions are to be controlled from the pan-tilt control panel,
select a cable which is long enough to support the connections when the pan/tilt head is moved upward and downward, as
with the cables listed above.
(Recommended cable: S14 a 7.5BMD-D24 made by Fujinon)
10 |
ACEC
PANASONIC
