3gb10082.fm5 Page 2 Monday, September 6, 2004 3:19 PM
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check6.Electrical connection
a.Cut and remove the shrink-wrap.? Electrical connections must be carried out by a
b.Remove the top protection and the protective qualified technician in compliance with the
corners.manufacturer?s instructions and the current
c. Remove the bottom protection by tilting and standard safety regulations.
turning the appliance on one rear bottom ? The technical data (voltage, power and fuses)
corner.
are given on the rating plate on the rear of the
2.Remove the transport bracketappliance.
? The appliance is fitted with transport screws and
? The appliance must be connected exclusively by
a transport bracket to prevent damage during means of a socket with an earth connection in
transport. Before using the washing machine
you must remove the transport bracket (see accordance with current regulations. The
appliance must be earthed by law. The
?Installation/Remove the transport bracket?).
Do not forget to screw back 4 screws to the rear manufacturer declines all liability for damage to
panel by which was fixed the transport bracket - to persons or property deriving directly or
avoid noisy and vibration of the machine.indirectly from failure to observe the directions.
3.Install the washing machine? Do not use extension leads or multi sockets.
? Place the appliance on a flat and stable floor ? Before any maintenance on the washing
surface.machine disconnect it from the mains supply.
? Adjust the feet to ensure that the machine is ? Access to the mains plug or to disconnection
stable and level (see ?Installation/Adjust the from the mains supply via a double-pole switch
feet?).
must be ensured at all times following the
4.Water supplyinstallation.
? Connect the water supply inlet hose in
? Do not operate the washing machine if it has
accordance with the regulations of your local been damaged during transport. Inform the
water company (see ?Installation/Connect the
water inlet hose?).After-Sales Service.
? Mains cable replacement is only to be carried out
? Water supply: Cold water only
? Tap: 3/4? threaded hose connectionby After-Sales Service.
? Pressure:100-1000 kPa (1-10 bar).? The appliance must be connected to an effective
?For Great Britain & Ireland only: earthing installation, in compliance with the
regulations in force. In particular, appliances
? Water inlet: hot and cold fill. The warm water
inlet temperature must not exceed 60° C.?installed in premises containing a shower or a bath
5.Drain hosemust be protected by a differential residual current
? Connect the drain hose to the siphon or hook it device of at least 30 mA. Earthing the appliance is
over the edge of a sink with the ?U? bend (see obligatory under the law. The manufacturer declines
?Installation/Connect the water drain hose?).all liability for damage to persons or property
deriving either directly or indirectly from failure to
? If the washing machine is connected to a built-observe the directions above.
in drainage system, ensure the latter is equipped
with a vent to avoid simultaneous loading and ? The washing machine may only be used in the
household for the prescribed uses.
draining of water (siphoning effect).
Dimensions:
Width:400 mm
Height:900 mm
Depth:600 mm
2 |
ACEC
WHIRLPOOL
