00142GB.fm5 Page 11 Wednesday, September 20, 2000 10:10 AM
LIQUID BLEACH (HYPOCHLORITE)
2. Pre-bleach method:Warning: Bleaching is only possible in a cold
Laundry with heavy stains may bewash, otherwise your laundry and your appliance
PRE-BLEACHED in the machine prior to carrwill beying damaged.
out a normal wash programme. Proceed by Poor the diluted bleach into chamber and start
diluting the bleach in approximately 1l wthe maater chine.
outside of the washing machine in a small
After this pre-bleach wash, do a normal wash, in
container.
which more not bleachable laundry can be added.
For a machine with temperature selector:Add detergent into chamber and start a wash
Turn the programme selector to programmeprogramme. 4.For this subsequent wash a lower
Turn the temperature seleMinctor to. temperature wash programme (for exa°C) mple 40
Warning: Bleaching is only possible in a cold can be sufficient because of the pre-bleach
wash, otherwise your laundry and your appliantreatment. In this way ce energy can be saved.
will be damaged.Note:
For a machine without temperature selector:Bleach should only be used with bleachable
Turn the programme selector to programmefabr5.ics.
Press the special option bu?cold wastton ? h
(if available).
DYEING
Commercially available products usually co Onnsily use pst roducts designed for use in
of a dye colour, fixing agent and salt.washing machines.
Pour the dye colour, fixing agent and sal tFoll directlow the y manufacturer?s instructions.
into the empty drum, and only then load thePlastic an d rubber components of the
laundry.machine can be stained by dyes.
REMOVING THE FILTER
WHEN TO REMOVE THE FILTER10.Pour 1/2 litre of water into the detergent
drawer and check that water does not leak
Check and clean the filter at least 2 or 3 times
a year.from the filter.
11.Close the cover.
When the appliance does not drain or spin
properly.
When the pump is blocked by an object
(buttons, coins, safety pins).
Important: Make sure that the water has
cooled before draining.
REMOVING THE FILTER
1. Switch off the appliance and drain the water (see
next paragraph?Dra ining residual ?).water
2. Open the filter cover with a coin.
3. Place a tray or container beneath the cover.
2
4. Slowly turn the filter anticlockwise without
6
unscrewing it completely (using pliers to
handle the filter grip makes screwing easier).
5. Wait until all the water has drained off.
6. Now unscrew the filter completely and
remove it.
7. Remove any foreign material from the filter.
8. Check that the pump rotor moves freely.
9. Insert the filter and screw it in clockwise firmly
4
until it locks.
11 |
ACEC
IGNIS
