PREPARING THE LAUNDRYSELECTING A DRYING TIME OR A PROGRAMME, FILTERAFTER-SALES SERVICE
AND OPTIONS
1. Check that all fastenings are closed and that Clean the lint filter at the end of every drying If, after carrying out the above checks the
pockets are empty. Drying Time or Programme and Options:cycle:malfunction persists or appears again, turn
1. Open the door.
2. Turn the articles inside out.? To select a drying time or a programme, turn 2. Pull the filter upwards.the dryer off and call our After-Sales Service
3. Place laundry loosely in the drum to make the time selector knob clockwise.(refer to guarantee).
sure it doesn?t become tangled.? To select an option (if available), press the 3. Remove lint using a soft brush or your Please specify:
fingertips.
Sort laundry as follows:corresponding button.4. Push the filter firmly back into place. ? The nature of the fault.
A) By care symbols ? Press the button again to cancel the option.? The dryer type and model.
(on the collar or inside seam):BUILT-IN INSTALLATION? The service code (the number after the word
STARTING AND COMPLETING A DRYING CYCLE
Service on the adhesive rating plate) on the
Suitable for tumble drying1. Having selected the desired drying time or To built in the dryerright-hand side when the door is open.
programme and options, press the Start ? Your full address and phone number.
Tumble drying with reduced drying 1. It is recommended to not remove the work-
intensity onlybutton.top.
If the laundry is not removed at the end of 2. Connect the dryer to an external ventilation
Do not tumble drythe drying cycle, an automatic anti-crease system in order to prevent steam from
B) By amount and thickness/weightcycle will operate for maximum 12 min. The damaging your furniture during the years.
drum rotates at regular intervals, preventing
Whenever the load to be dried exceeds dryer the laundry from creasing.TROUBLESHOOTING GUIDE
capacity, separate laundry according to 2. On completion of the drying cycle, set the time
weight (e.g. towels from thin underwear).If a fault occurs, before contacting our After-
selector knob to position ?0?. Sales Service, make the following checks to
C) By type of fabricsThe dryer indicator lamp ?On? switches off.
Cotton/linen: towels, cotton jersey, bed and try and remedy the problem:
table linen made of cotton or linen.INTERRUPTING A DRYING CYCLEDrying takes too long / laundry is not dry
Synthetics/Easy Care: blouses, shirts, overalls, To interrupt the dryer during operationenough:
etc. made of polyester or polyamide, as well as ? Was the correct drying time selected?
cotton/synthetic mixes.1. Set the time selector knob to the programme ? Was the inserted laundry too wet (Washing
D) By drying level?Airing?.machine spin speed less than 800 rpm)?
? Sort into: iron dry, cupboard dry, etc.2. Wait at least 5 minutes before opening the ? Is the lint filter dirty (filter indicator lamp
Do not tumble dry: woollens, silk, nylon door to allow the dryer to cool down. on)?
For your safety the drying time stops
stockings, delicate embroidery, fabrics with The dryer does not operate:
metallic decorations, bulky items such as automatically if you open the door.? Is the power plug properly inserted into the
sleeping bags, etc.3. To restart, after door opening, close the
door and press the Start button again. mains electricity socket?
Important: only use specific indicated dryer-? Is there a power failure?
safe additives and rinse items that have been
treated with stain remover thoroughly in plenty ? Has the fuse blown?
? Is the door properly closed?
of water before drying. Only use specific ? Has the drying time been selected?
indicated dryer-safe plastic items and never
dry rubber or articles contaminated with ?Has the Start button been pressed?
vegetable oil in the dryer.Lint filter indicator lamp on:
? Is the lint filter clean?
? Is the vent hose blocked?
5019 307 00238 |
ACEC
WHIRLPOOL
