PREPARING THE LAUNDRYSELECTING A DRYING TIME OR A PROGRAMME, FILTERAFTER-SALES SERVICE
AND OPTIONS
1. Check that all fastenings are closed and that Clean the lint filter at the end of every drying If, after carrying out the above checks the
Drying Time or Programme and Options:
pockets are empty. cycle:malfunction persists or appears again, turn
2. Turn the articles inside out. To select a drying time or a programme, turn 1. Open the door.the dryer off and call our After-Sales Service
3. Place laundry loosely in the drum to make the time selector knob clockwise.2. Pull the filter upwards.(refer to guarantee).
sure it doesn?t become tangled. To select an option (if available), press the 3. Remove lint using a soft brush or your Please specify:
corresponding button.fingertips.
Sort laundry as follows: the nature of the fault.
4. Push the filter firmly back into place.
Press the button again to cancel the option.
A) By care symbols the dryer type and model.
(on the collar or inside seam):BUILT-IN INSTALLATION the service code (the number after the word STARTING AND COMPLETING A DRYING CYCLE
Service on the adhesive rating plate) on the
Suitable for tumble drying1. Having selected the desired drying time or To built in the dryer
right-hand side when the door is open.
programme and options, press the Start
Tumble drying with reduced drying 1. It is recommended to not remove the work- your full address and phone number.
intensity onlybutton.top.
If the laundry is not removed at the end of
2. Connect the dryer to an external ventilation
Do not tumble dry
the drying cycle, an automatic anti-crease
system in order to prevent steam from
cycle will operate for maximum 12
B) By amount and thickness/weightdamaging your furniture during the years.
min. The drum rotates at regular intervals,
Whenever the load to be dried exceeds dryer
preventing the laundry from creasing.TROUBLESHOOTING GUIDE
capacity, separate laundry according to
weight (e.g. towels from thin underwear).2. On completion of the drying cycle, set the If a fault occurs, before contacting our After-
time selector knob to position ?0?.
C) By type of fabricsSales Service, make the following checks to
The dryer indicator lamp ?On? switches off.
Cotton/linen: Towels, cotton jersey, bed try and remedy the problem:
and table linen made of cotton or linen.INTERRUPTING A DRYING CYCLE
Drying takes too long / laundry is not dry
Synthetics/Easy Care: Blouses, shirts,
enough:
overalls, etc. made of polyester or To interrupt the dryer during operation
Was the correct drying time selected?
polyamide, as well as cotton/synthetic 1. Set the time selector knob to the programme
Was the inserted laundry too wet (Washing
mixes.?Airing?.
machine spin speed less than 800 rpm)?
D) By drying level2. Wait at least 5 minutes before opening the
Is the lint filter dirty (filter indicator lamp
Sort into: iron dry, cupboard dry, etc.door to allow the dryer to cool down.
on)?
Do not tumble dry: Woollens, silk, nylon For your safety the drying time stops
automatically if you open the door.The dryer does not operate:
stockings, delicate embroidery, fabrics with
metallic decorations, bulky items such as 3. To restart, after door opening, close the Is the power plug properly inserted into the
sleeping bags, etc.door and press the Start button again. mains electricity socket?
Is there a power failure?
Important: only use specific indicated dryer-
safe additives and rinse items that have been Has the fuse blown?
treated with stain remover thoroughly in plenty Is the door properly closed?
of water before drying. Only use specific Has the drying time been selected?
indicated dryer-safe plastic items and never
Has the Start button been pressed?
dry rubber or articles contaminated with
Lint filter indicator lamp on:
vegetable oil in the dryer.
Is the lint filter clean?
Is the vent hose blocked?
5019 307 00486 |
ACEC
WHIRLPOOL
