3. Editing
3. EditingModifying a parameter valueSelecting a parameter
In Play mode and Individual mode, you can edit each
effect, set noise reduction and program level, and
modify the program name.
In Phrase Trainer mode, it is possibDRIVE-le to edit the
AMP and CABINET effect blocks, but it is not possible to
perform editing operations that use the name display or
MASTER/VALUE display, or the cursor switches or the
MASTER/VALUE switches.
DRIVETREBLEBASS
LEVELMIDDLE
During editing, the edit icon in the display will blink.
The parameter assigned Instead of the five value knobs, you can also use the
to the knob you moved
cursor switches to select parameters, and use the
Value of the parameterMASTER/VALUE switches ( , ) to adjust the valueEdit icon
of the parameter currently shown in the name display.
If you do not wish to use the DRIVE-AMP effect block,
Editing effects
press the DRIVE-AMP effect block select switch until
Rotate the effect select knob of the effect block that you
the LED goes dark. The DRIVE-AMP effect block is
wish to edit, or press the corresponding effect block
now bypassed, and the name display will indicate O-
select switch. The effect block LED will begin blinking,
OFF-.�
indicating that it has been selected for editing.
For some effects, it is not possible to simultaneously use
Use the effect select knob, effect block select switch,the MODULATION and PEDAL effect blocks, or the
and value knobs to edit the settings.PEDAL and AMBIENCE effect blocks. If you attempt to
turn on both effect blocks in such a combination, the
If you wish to save the edited effect, perform the block that had been turned on will automatically be
OProgram write� operation. If you fail to do this, the effturned offect.
program will revert to its original settings when you turn
off the power or select a different program.
Quick Editing for the DRIVE-AMP
As an example, we will explain how to edit the TUBE
OD (Tube Overdrive) effect of the DRIVE-AMP block.effect block
1. If the name display indicated OTUBE OD� whenIn the default state of each mode, the DRIVE-AMP
you pressed the effect block select switch, simplyeffect block parameters used by the selected program
continue. If not, turn the DRIVE-AMP effect selectare assigned to the value knobs (except when the effect
knob to the TUBE OD position. If the effect selectis off).
knob was already located at TUBE OD, first select aBy rotating the respective value knobs, you will enter
different effect model, and then turn the knob backEdit mode (the effect block LED will blink); the name
to TUBE OD.display will indicate the parameter name, the MAS-
TER/VALUE display will show the value, and the
2. The effect block LED will begin blinking, indicating
sound will change.
that it has been selected for editing. (The name
display will indicate the model name as OTUBEIf you wish to change an effect that is in use, use the
effect select knobs to select the desired effect.
OD.�) If you selected a programmed effect, the
ORIG icon will light.It is not possible to edit when other functions are
assigned to the value knobs, when the AX1000G is
3. The five value LEDOs will light, and the correspond-bypassed, muted, or recording in Phrase Trainer mode.
ing value knobs will be assigned to DRIVE,
LEVEL, TREBLE, MIDDLE, and BASS respec-
tively, and will function as knobs that adjust the
value of each parameter. (Refer to p.16, OEffect
parameters.�)
4. Rotate the knobs and the sound will change. The
name display will indicate the name of the
parameter assigned to that knob, and the MAS-
TER/VALUE display will indicate the value. At this
time, the ORIG icon will light when the position of
the knob matches the original value N i.e., the
value before you began editing.
12 |
ACEC
KORG
