You can also use the MASTER/VALUE switches to
Setting the noise reduction and
change the character.
program levelsIf you wish to save the modified program name, you must
perform the OProgram write� operation. If you turn off the
1. If you are in Play mode, press the NR-PRG LEVEL
power or select a different program without writing the
switch.program, the program name you edited will revert to its
previous setting.
2. By rotating value knobs 1 or 2, or pressing the NR-
PRG LEVEL switch, you can access the screen
displays for adjusting the noise reduction and
Writing programs
setting the level for each program.
HereOs how to write an edited program.
3. To adjust the amount of noise reduction, use value
1. Press the WRITE switch, and the name display will
knob 1 (range OFF...10: shown in the MASTER/
indicate O3WRITE 3.� The bank number display
VALUE display).
and the program LED will blink.
4. To adjust the level of each program, use value knob
2. Use the MASTER/VALUE switches ( , ) to select
2 (range 0...10: shown in the MASTER/VALUE
the writing destination bank, and use the cursor
display).
switches ( , ) to select the writing destination
program.
3. Press the WRITE switch once again, and the
display will read OCOMPLT � to indicate that the
program has been written. You will then return to
Play mode.
You can also use value knob 5 or the bank switches to
select the bank, and the program switches to select the
Noise reductionLevelprogram.
If you decide not to write, press the EXIT switch to
Instead of value knobs 1 and 2, you can also use the
cursor switches (, ) to select a parameter and usecancel the Write operation.
the MASTER/VALUE switches to adjust the value of the
parameter.
Select the bankSelect the program
Depending on the guitar that you use, raising the noise
reduction setting too high may cause the sound to be cut
off at low levels.
The volume of each program will change depending on
the guitar that you use. Adjust the program level for your
guitar.
If you wish to save the noise reduction and program level
settings that you edited, you must perform the OProgram
write� operation. If you turn off the power or select a
different program without writing the program, the
3. Editing
program you modified will revert to its previous settings.
Select the programSelect the bank
Modifying program names
If you write an edited program to a different program
Press the RENAME switch and specify the programnumber, the program that was overwritten will be lost.
name (maximum 7 characters). Use the cursor switchesIt is not possible to write to a preset program.
( , ) to select the character that you wish to change
(the character will blink). Then use value knob 5 to
select the desired character. The available characters
are shown below.
Available characters
Move betweenSelect characters
character positions
13 |
ACEC
KORG
