How Do I�: CHANGE DELAY, REVERB, CHORUS, ETC. SETTINGS?
CHANGE DELAY, REVERB, CHORUS, ETC.
SETTINGS?
Next to the Edit Rows (you know, all those rows of text in the center of the front
panel), youOll see six little buttons stacked one over the other. Press the one thatOs
closest to the parameters you want to change. If the little red arrow isnOt pointing at
the parameter row you want to play with, press the button again. Now you can access
all of those parameters using the knobs below them. Remember, those six knobs
change function, depending on which Edit Row you have selected. For instance, when
youOve selected the Reverb Edit Row, the knob under the word DRIVE isnOt the Drive
knob anymore � itOs now the Reverb Type knob. ThereOs no editable parameter thatOs
more than 2 button presses away and more than half are available with a single button
press � no hard to Ţnd software pages!
GET BACK TO WHERE I STARTED?
If an individual channel in the User bank gets too twisted to deal with, you can always
go back to the beginning by simply copying the corresponding factory preset over it
(the User bank starts out as just a copy of the Preset bank). To do this, go to the User
channel you want to get rid of (letOs just use U04A as an example), press the User/
Preset button to go to the Factory Presets bank, and press Save twice. ThatOs it, youOve
9Y2restored that individual User channel to what it was when you Ţrst pulled your AX2
out of the box. You can also reset the entire User bank to the factory settings by
performing a System Reset. To do this, turn the amp off, hold down the User/Preset
and Save buttons, and power the amp back on while youOre holding down those
switches. This will overwrite everything in the User bank with the original factory-
programmed setups and reset all Global modes to factory default, destroying anything
you might have saved before (sometimes a good thing, but certainly something to be
done with quite a bit of caution!) |
ACEC
OTHERS
