AxiomLineUserGuide
< The LCD display will ash the currently assigned note for the pad.
< Enter the note number you want the pad to transmit using the numeric keypad.
< Press the Enter key to conrm.
< Press the Advanced button again.
< The Data 2 and Data 3 keys can be used in the same fashion to specify the ON value (this should be 127 in most
cases) and the OFF value (this should be 0 in most cases).
3.5.4PressureControl
Using the pressure control, the pads give you a different type of performance option on your Axiom. You can control parameters
on your software in a way that would not be possible on a standard dial or slider. The pressure pads can be used to make some
very interesting effects.
As weve seen above, each pad can be assigned an individual MIDI controller number. It is also possible to assign minimum and
maximum values to the controller. As you apply more and more pressure to the pad, the value of the controller you are sending will
increase, until the maximum value you specied is reached. On release, the pad will return to the minimum value you specied.
To set the controller for a pressure pad with a minimum and maximum value:
49- and 61-note versions:
< Select the pad as described in section 2.
< Press the Ctrl Assign button.
< The LCD display will show the currently assigned controller for the pad.
< Enter the controller number from Appendix C that you want the pad to send.
< If you want to specify a minimum value limit, press the Data 2 button and enter the minimum value.
< If you want to specify a maximum value limit, press the Data 3 button and enter the maximum value.
25-note version:
< Select the pad as described in section 2.
< Press the Advanced button.
< Press the Ctrl Assign key.
< The LCD display will show the currently assigned controller for the pad
< Enter the controller number from Appendix C that you want the pad to send, using the numeric data entry keys.
Press the Enter key to conrm.
< If you want to specify a minimum value limit, press the Advanced button, followed by the Data 2 key and enter the
minimum value. Press the Enter key to conrm.
< If you want to specify a maximum value limit, press the Advanced button, followed by the Data 3 key and enter the
maximum value. Press the Enter key to conrm.
3.5.5PadCurve
The Pad Curve setting is used to set the response curve of all eight pads. It is not possible to set the response curve of the pads
independently.
There are nine velocity response curves and three xed curves.
To change the velocity curve for the pads:
49- and 61-note versions:
< Press the Bank LSB and Bank MSB buttons together to access the Pad Curve setting.
< The LCD will show the currently selected pad curve. Proceeded by a C if a curve is selected, or F if a xed
velocity* is selected.
< Enter the new curve number using the numeric keypad or use the -/+ keys to step through the options.
23
Section3:AdvancedFeatures |
ACEC
M-AUDIO
