AY-XP08/10/13CE
AE-X08/10BE-C
AE-X13BE
How to remove the horizontal louver
CN101 and CN102Slightly pull down the hinge area, deflect the louver, and
unhook it from the hinge. Remove the shaft from each of
the left and right sides.
5. Remove 2 connectors.
How to remove the HI VOLTAGE UNIT.
1. Remove the HIGH VOLTAGE UNIT.
6. Pull the board.
Drain pan and related(Press and spread the hook, and HI VOLTAGE will
be ready for removal.)
How to remove the DUST SENSOR, the THERMISTOR
and the GAS SENSOR.
Remove the DUST SENSOR, the THERMISTOR, and
the GAS SENSOR.
GAS SENSOR
DUST SENSOR
1. Remove 3 screws fixing motors.
THERMISTOR
Drain Hose
Drain pan
Projection
Groove
(Press and spread the hook,and GAS SENSOR will be
ready for removal)
How to remove the display board unit 2.
The display board unit 2 is pushed in the direction of
arrow 1 .
And it is made to slide in the direction of arrow 2 , and
To disconnedTo reconnectremove.
2. Turn the cap area of the drain hose counterclockwise,
and remove it from the drain pan.1
During installation, turn the drain hose to the state of
2
the Oengagement position�.
After reinstallation, verify that it is securely fastened.
display board unit2
38 |
ACEC
SHARP
