PHILIPS AZ1145/17 Instruction Manual

XP AZ 1145/17 02-02-2000 11:56 Pagina 11
AZ 1145 /17 page 11
DIGITAL TUNER
TUNING TO RADIO STATIONS
1. Select TUNER source.
STOPYOPEPRESETBAND
"is displayed briefly and then the radio stationNSEARCHPLAY123
RECORD
frequency is shown.C
PROGRAMDSENSORREMOTE
2. Press BAND once or more to select your waveband.ALLEnglishREPEAT
SEARCH
3. Press  or § on the set or on the remote control and release
PROGRAM
when the frequency in the display starts running.
" The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
FM
" If an FM station is received in stereo, STEREO is shown.
TUNER
4. Repeat step 3 if necessary until you find the desired station.STEREO
Y To tune to a weak station, press  or § briefly and
repeatedly until you have found optimal reception.
5. Adjust the power slider to TAPE/OFF position to switch off the
set.
To improve radio reception
� For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
� For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Favorite station selection
For your favorite 3 tuner stations, you can use the easy one-touchPENSEARCH123PRESETBAND
PLAY
programming and selection 1, 2 or 3 buttons.RECORD
REMOTESENSOR
1. Tune to your desired station (see Tuning to radio stations).GRACMPAEALTLD
2. To store your station, press 1, 2 or 3 for 2 seconds or more.SEARCH
" Display: shows PROGRAM briefly, your favorite preset stationPROGRAM
number and the tuner frequency.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.PRESETBAND
SEARCHPLAY123
1. Tune to your desired station (see Tuning to radio stations).RECORD
REMOTESENSOR
2. Press PROGRAM to activate programming.MTD
� Display: PROGRAM flashes.SEARCH
3. Press PRESET 4 or 3 once or more to allocate a number fromPROGRAM
1 to 30 to this station.
4. Press PROGRAM again to confirm the setting.
� Display: PROGRAM disappears, the preset number and the
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
� You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press 1, 2, 3 or PRESET 4 or 3 until the desired preset station is
displayed.
11