AZ 1565 /00 page 8
DIGITAL TUNERCD PLAYER
EnglishChanging tuning grid (some versions only)
In North and South America the frequency step between adjacent
channels in the AM (MW) and FM band are 10 KHz and 100 KHz
respectively. In the rest of the world this step is 9 KHz and
50 KHz. Usually the frequency step has been preset in the factory
for your area.
CASSETTE RECORDERZ 1565O
STOP
1.Check that the set is in the TAPE/OFFposition and switchedPLAYYPAUSE
off.PROGLOBATWFMSOUND CONTROL CENTER
AMPROGVOLTUNERLWSHUFFLEPRESET
SENSORREMOTE
2. To select 9KHz: Simultaneously, press PROGand REPEATonYY
SHUFFLEBAND
the set. SEARCHREPEAT
3.Switch the set on to TUNERand then release the controls.
YTo select 10KHz : Repeat steps 1-3 but in step 2,
D
simultaneously, press PROG and TUNING ¤ on the set.
� When you tune to radio stations, the display shows tuning in
either steps of 9 or 10.
� All preset stations will be affected and you may need
reprogramme the preset stations.
Playing a CD
1.Select CDsource.
2.Press OPENYCLOSEto open the CD door.
CD RADIO CASSETTE RECORDERAZ 1565
STOPOPENC
a Display:when you open the CD door.PLAYYPAUSELOSE
PROGLOBAWTFMSOUND CONTROL CENTER
AMPROGVOLTUNERSHUFFLEPRESET
LWREMOTE
3.Insert a CD or CD-R(W) with the printed side facing up andSENSORY
Y
SHUFFLEBAND
press OPENYCLOSE to close the CD door.REPEATSEARCH
a Display: as the CD player scans the contents of a CD.
The total number of tracks and playing time are then shown.
a Display:is shown if the CD R(W) is not finalised.
4.Press PLAYYPAUSE 2;(on the remote control 2;) to start
playback.
a Display: Current track number and elapsed playing time of the
track during CD playback.
5.To interrupt playback press PLAYYPAUSE2;.
Press PLAYYPAUSE 2; again to resume play.
a The display freezes and the elapsed playing time flashes when
playback is paused.
6.To stop CD playback, press STOP9.
Note: CD play will also stop when:
� the CD door is opened;
� the CD has reached the end (unless you have selected
REPEAT ALL);
� you select another source: TAPE / TUNER.
8 |