AZ 1565 /00 page 6
BASIC FUNCTIONSGENERAL INFORMATION
English
SWITCHING ON AND OFF
Y Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
Y The set is switched off when the POWER slider is in the
TAPE/OFF position and the keys on the tape deck are released.
MECD REWRITSLUCD SYNCRO STRAABL
� The volume, sound settings and tuner presets will be retained inOUONDCONTROLCENTERVTE R
CD RADIO CASSETTE RECORDER
the set's memory.AZ 1565STOPPLAYYPAUSE
ADJUSTING VOLUME AND SOUND
1.Turn the VOLUME/ SOUND CONTROL CENTERcontrol
clockwise to increase or anti-clockwise to decrease volume on
the set (or press VOLUME 3 or 4 on the remote control).
a Display shows the volume level indication VOL and a number from
0-32.ECD RESOLUMCD SYUNDCONTROLCENTERVO
2.To adjust the bass, mid and high frequency levels, press DIGITALCD RADIO CASSETTE RECORDERAZ 1565
STOPPLAYYPAUSE
EQUALIZER once or more until the desired option is displayed.
While the option is shown, turn the VOLUME/ SOUNDPROLOBATFSOUNDCON
CONTROL CENTER control to increase or decrease
(- 5 to + 5 maximum) the desired frequency.
+
Y
a VOLUME can also be adjusted in this way with a level rangeYYY
0
from 0-32.YYY
Y
3.Press DIGITAL DBBto switch dynamic bass boost on or off.�
a If on, the DIGITAL DBB light goes on.
4.Press INCREDIBLE SURROUNDto switch the surround sound
effect on or off.
VOL
a If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with
different types of music.
GENERAL INFORMATION
General maintenance
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
Y To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
Y Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
Y The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
6 |
ACEC
PHILIPS
