TRICITY BENDIX BD921W/1 Instruction Manual

CONNECTING TO THE MAINS TERMINALNOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
Warning: This cooker must be earthed.
out before the cooker is connected to the mains
lMake connection as shown in Fig. 6 bysupply and re-checked after fitting.
proceeding as follows:-
Earth (Green orRed or
Green/Yellow)
Brown
Blue or
Black
5mm
Earth Tab
Mains
Cable
Fig.6
lPreform wires to the appropriate shape to suit
fitting into the mains terminal block.
lStrip inner insulation on wires using wirestrippers.
lTwist the bared wires using pliers.
lCut bared wires 10mm away from the end of the
inner insulation. Where uninsulated Earth wires
are used ensure they are suitably sheathed to
leave 10mm bare wire to fit into the terminal.
lClamp bare wires into the relevant terminal and
check they are held by tugging each one in turn.
lClamp the mains cable securely ensuring 5mm of
the outer insulation is inside the terminal block
and that the wires are not taught but not so slack
as to cause any fouling. See Fig. 6.
lPlace fuse/ miniature circuit breaker in circuit and
switch on at mains.
CONNECTING TO A HOB OR COOKER POINT
Warning: This cooker must be earthed.
lEither follow in general terms the instructions for
connecting to the terminal block or refer to the
hob suppliers installation instructions.
Feed the cable through the cabinet and
arrange to route the cable away from the
cooker which may become hot.
CHECKING ELECTRICAL CONNECTIONS
lConfirm the cooker is correctly connected by
switching on and observing the various oven
functions indicators.
lThe electronic timer will flash on and off.
11