The control panel
1. MAINS ON indicator light5. Indicator lights
Phase indicator lights
2. MAINS ON push buttonWASH
illuminates when the washing phase is running
DRYING
3. Door handleilluminates when the drying phase is running
END
illuminates when the washing programme has ended
4. Programme selection push buttons
Salt indicator light
SALT
illuminates when the salt has run out and the salt
container requires refilling.
Before use
Before using your dishwasher for theWater hardness
first time:LevelClarkeFrenchPPMUse of
degrees degrees(Parts persalt
1.Ensure that the electrical and water connections comply (°TH)Million)
with the installation instructions
1< 6< 8< 80NO
2.Remove all packaging from inside the appliance
26 - 218 - 3081 - 300YES
3.Set the water softener
322 - 3531 - 50301 - 500YES
4.Pour 1 litre of water inside the salt container and then fill 436 - 4951 - 70501 - 700YES
with salt
550 - 6371 - 90701 - 900YES
5.Fill the rinse aid dispenser
6.Run a Rinse and Hold programme.
If your water is level 1 it is already soft and therefore there
is no need to use salt.
With the setting of the water softener at level 1 the salt
Setting the water softener
indicator light on the control panel will always remain off.
The dishwasher is equipped with a water softener designed toUse salt from level 2 upwards.
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of theFrom level 2 upwards, if salt refilling is necessary, the salt
appliance.indicator light will illuminate only in setting mode and at
The higher the content of these salts, the harder your water is.the end of the washing programme.
Water hardness is measured in equivalent scales, ClarkeDuring the run of the programme it will remain off.
degrees, French degrees and PPM (parts per Million).
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener should be
adjusted.
4 |
ACEC
TRICITY BENDIX
