30> Timer programming
Switch on the Timer function!
SETUPPress to enter the setup functionThe Timers you have programmed into
then
the BeoSound Ouverture can all be
Press until TIMER? is displayed
executed with or without the loud-
The green light shows you that the Timer Play
speakers being cut in.function is cut in.
then
PLAYPress to see the current Timer setting
in the displayNote: If you forget to switch the Timer sound
For the loudspeakers to be cut in � so
thencontrol on, the programmed Timers willbe
that you can hear your Timer Play
Press to switch from ON to OFF, orexecuted at the specified times, but the speakers
programmings, you must switch on the
vice versawill be muted.
thenTimer sound control!
PLAYPress to store the displayed TimerNote: If you use the BeoSound Overture in a fully
settingintegrated Bang & Olufsen AV system (see page
A small green light then appears in the
39), the Timer sound control must be set on/off
display (next to the stand-by light).
via the TV. In that case, the green light in the
Ouverture display will not switch on.
See how to switch the Timer sound
control on or off to the left on this
page... |
ACEC
BANG&OLUFSEN
