Fig. 9Fig. 13
1Hook the decora-If the appliance has
820
tive panel onto the870been Ţtted into a
B
top part of thespace 820 mm
door, inserting thehigh and the maxi-
Cpins (B) (on themum height of the
170
door) into the elon-220base plate is 100
gated holes (1) (inmm, Ţt the front
the top bracket Ţt-600cover plate by
ted to the panel)pushing the two
135
(Fig. 9).185vertical lugs into
2
D533D518
the rectangular
Insert the securing screws (C) through elongatedholes on the bottom
holes (2) and Ţx the panel without tightening theside of the ventilation duct until they click. The plate
screws (Fig. 9).can be adjusted backwards or forwards in the holes
(Fig. 13).
Fig. 10
Fig. 14
Once the top of the
panel has been820
If the base plate is
870
correctly posi-between 100 and
tioned, Ţx it135 mm high, cut it
through the holesas shown in
in the bottomFig. 15 and mount
bracket, without100
as described
150
tightening theabove.
20�80
screws (Fig. 10).If the base plate is
between 135 and
D471170 mm high, cut it
D519as shown in
Fig. 11
Fig. 13.
Check the position
Fig. 15
Dagain by slacken-
ing the screws andIf the appliance
820
pins then, once870has been Ţtted
the best positioninto a space 870
has been ob-mm high and the
tained, fully tightenmaximum height
all the Ţxings.of the base plate is
Cover the visible150 mm, Ţt the
part of the top100�135
front cover plate
150�185
D472bracket on the panel as described in
with plastic cover (D), inserting it in the locations pro-Fig. 14.
vided in the bracket.D520
Fig. 12If the base plate is between 150 and 185 mm high, cut
it as shown in Fig. 15.
Once the door has
If the base plate is between 185 and 220 mm high, cut
ben correctly ali-
it as shown in Fig. 13.
gned, tighten the
holding nuts on
the Ţxing brackets
and attach the ap-
pliance to the adja-
cent units and the
bottom of the work
surface (Fig. 12).
D517
7 |
ACEC
TRICITY BENDIX
