BR600_e2 201Z8 ???-??e??xýe
Uxý9 V?p?Â
Utility Parameter List
Utilities include the following :Foot Switch Assign (Foot SW)
Y OSystem parameters� for setting functions affecting the Valid Settings : PLAY, PUNCH, FX
entire BR-600
(Initial value : PLAY)
Y OSync parameters� for setting synchronized This sets the function for the foot switch (FS-5U or DP-2;
performance functionssold separately) connected to the FOOT SW/EXP PEDAL
Y OScrub parameters� for setting scrub functionsjack.
PLAY :Controls the recorderOs PLAY and STOP
About the System Parametersfunctions.
This section describes the System parameters.
PUNCH :Controls Punch In/Out.
FX :Controls the insert effects On/Off.
1
Confirm that [PAD] is not lit, then press [UTILITY].
Audio Sub Mix Switch (Sub Mixer)
2Valid Settings : ON, OFF
Press CURSOR [] [] to move the cursor to
(Initial value : OFF)
OSYS,� and press [ENTER].
This setting turns the Audio Sub Mix function (output mix
of the external inputs from LINE IN) on and off.
3
Using CURSOR [] [], select the System
parameter, then make the setting with the VALUE/
AB Quantize (AB Qtz)
TIME dial.
Valid Settings : ON, OFF
(Initial value : OFF)
This setting turns the OQuantize function� on and off.
LCD Contrast
OQuantize� is a function that enables you to set the start and
Valid Settings : 1�17 (Initial value : 12)
end points in measure units when making the settings for
This sets the display contrast.repeat playback (the repeated portion).
Pad SensRemain Information (Remain Inf)
Valid Settings : HEAVY,MID,LIGHT,FIX Valid Settings : ON, OFF
(Initial value : OFF)
(Initial value : MID)
This indicates the remaining amount of recording time
This sets the sensitivity of the drum pads.
available in the display during recording standby or while
HEAVY :Sensitivity is reduced. Although sounds cannot be recording is in progress.
played at a high volume without tapping the pads
forcefully, it is easier to play sounds with small
differences in volume.Power Save Mode (PowerSave)
Section 6
Valid Settings : OFF, 1, 3, 5, 10
MID : Normal sensitivity setting.
(min) (Initial value : OFF)
LIGHT : A high sensitivity setting is used. Although this
This setting turns the OPower Save function� on and off.
permits sounds to be played at high volume
even when the pads are tapped only lightly, it
OPower Save� is a function that reduces power
does not allow minor changes in volume.
consumption through such power-saving measures as Re
FIX : Sounds play at a uniform volume (MIDI switching off the displayOs illumination if no operation is
v0.10
velocity value of 100), regardless of how hard performed for a set period of time (for one, three, five, or
the pads are tapped.
ten minutes). This is effective in preventing excess battery
drain.
201 |