2-2. Electrical Adjustment Using a VF Checker
2-2-11. Heater Voltage Adjustment2-2-12. Picture Frame Adjustment
NoteNote
This adjustment, O2-2-10. Focus Adjustment� and O2-2-12.This adjustment, O2-2-10. Focus Adjustment� and O2-2-11.
Picture Frame Adjustment� affect each other.Heater Voltage Adjustment� affect each other.
Therefore, repeat these adjustments until these specifica-Therefore, repeat these adjustments until these specifica-
tions are satisfied.tions are satisfied.
PreparationPreparation
. 16:9/4:3 switch (VF checker) ? 4:3. 16:9/4:3 switch (VF checker) ? 16:9
. BRIGHT control ? Mechanical center. Input the monoscope (4:3) signal to the VBS connector
. CONTRAST control ? Mechanical centeron the VF checker.
. PEAKING control ? Mechanical center
. Input the monoscope (4:3) signal to the VBS connector
on the VF checker.
. Setting of the signal generator (TG21A1001)
LUMINANCE ? OFF
CHROMINANCE ? OFF
(Or input the black burst signal using another(Viewfinder screen)
signal generator.)
. BRIGHT control ? Mechanical center
Adjustment Procedure. CONTRAST control ? Mechanical center
1. Equipment: Digital voltmeter
Adjustment Procedure
Test point: CP4 (H1)/VF-67
CP5 (H2)/VF-671.Adjustment point1RV7 (H-HOLD) /VF-67:
Adjustment point1RV6 (HEATER)/VF-67:Specification: If the upper left corner of the picture
Specification?:15 mV dc635 is distorted, makes right angle.
2. Confirm that the specification is met and horizontal
noise irrespective of its BRIGHT, CONTRAST and
PEAKING controls setting.
3. 16:9/4:3 switch (VF checker) ? 16:9
(Viewfinder screen)
4. Confirm that the specification is met and horizontal
noise irrespective of its BRIGHT, CONTRAST and2. Adjustment point1RV11 (V-LIN) /VF-67:
PEAKING controls setting.1RV13 (H-LIN) /VF-67
Specification: Minimize the distortion of the four
Setting after Adjustmentcircles at the corners of the resolu-
tion chart.
TG21A1001
LUMINANCE ? ON(To be continued)
CHROMINANCE ? ON
BVF-V20W/V20WCE2-11 (E) |