Using the Optional SP01 Shock-Mount
Using the Optional SP01 OSpider� Shock-Mount
For additional isolation, the C03 can be fit-
1ted on the optional SP01 OSpider� shock
mount. Follow the steps below the to
install the SP01.
00-10dB-10dB
YFirst, screw the SP01 shock mount
onto your mic stand or boom arm. If
youOre using a US 5/8� mic stand or
boom, remove the Euro adapter.
YRemove the C03 swivel mount by
rotating the threaded collar counter-
clockwise as shown in figure 1.
Y Install the C03 into the SP01 by fitting
the microphone into the center of the
web, positioning the C03 onto the bot-
THREADEDtom mounting plate.
COLLAR
YSecure the SP01 by reinstalling the
threaded collar, rotating clockwise
until tight. (Figure 2)2
YNow, loosen the thumb screw to
adjust the angle of the microphone
and position the C03 to the desired
location. Once set, tighten the thumb-
screw to secure the microphone in
SP01 00-10dB-10dBplace.
SHOCK MOUNT
Note: Be careful not to cross thread
or over tighten the threaded collar or
thumb screw.
THUMB
SCREW
THREADED
COLLAR
7 |
ACEC
SAMSON
