6StudioProjectswww.studioprojects.com7
TROUBLESHOOTINGTIPScont...C1
Shockmount Looks As If It Should Fit On Mic Stand, But For Some Reason, It The Studio Projects C1 is an externally polarized cardioid pressure gradient
Will not Screw On:transducer microphone with FET impedance converter. Diaphragm material
There are two standard thread sizes for mic stands, 5/8-27 and 3/8-16. Studio Projects shock-is 6?m mylar for natural reproduction of vocals and instruments. It features
mounts ship with a brass reducer installed, which allows for the 3/8-16 threads. For use with 5/8-dual selectable pads and high pass filters for a total of nine possible modes
27 mic stand threads, unscrew adapter from shockmount, using a small coin as a screwdriver. of operation. The output circuitry is active and is capable of driving long cable
Keep track of adapter when not in use you never know when you may need itruns. The C1 is useful for all manner of recording work and music styles.
ORIGINSANDMANUFACTURE
C1SPECIFICATIONS
Studio Projects Microphones are manufactured in Beijing, China by 797 Audio to a speci-
fication defined by Studio Projects, Gardena, California. All Studio Projects microphones Type: Single diaphragm pressure
are inspected and tested at the factory, then inspected and tested again at PMI Audio gradient condenser microphone
Groups facility prior to shipping. Studio Projects microphones meet the require-Polar pattern: Cardioid.
ments of electronic equipment sold both in the USA, Canada, and the European Union.
Frequency response: 30Hz~20000Hz.
APPLICATIONSSensitivity: 14mV/Pa=-37dB (0dB=1V/Pa).
Output impedance: <200 Ohm.
? Close miking of instruments with high sound pressure levelsLoad impedance: >1000 Ohm.
? Announcer?s mic for broadcasting/dubbing
Max. SPL: 131 dB SPL for 1% THD @1000Hz
? Home recording and project studios (0dB SPL=0.00002Pa).
? Vocalist recording
? Spot mic for: wind instruments, strings, percussion and guitar amps.Noise: (Line): 27 dB (A weighted) ---17 dB.
? XY - Coincident Cardioids
? Mid-Side MethodS/N ratio: 77 dB.
? Stereosonic Technique (Blumlein)Power requirement: 48 +/- 4V.
? Overheads
Current consumption: <2.5mA.
Circuit: JFET impedance converter, discrete balanced output.
Connector: Gold-plated 3-pin XLR
Pad: -10dB, -20dB
Low Cut: 6dB/octave at 75Hz or 150Hz
Diameter: 2.1 length: 8.9
Weight: 26.9oz |
ACEC
OTHERS
