ASSEMBLY
MOWER DECK BAFFLE (See Fig. 1)UPPER CORNER
RIBS
1Use Hardware - - GROUP "A"UPPER CORNER
RIBS
Raise your tractor mower deck to its highest position.
Install the hex bolt, and locknut through mower deck
SELF
baffle and tighten securely.TAPPING
SHOULDER
BOLTS
HEX BOLT
LANCED TABS
TOWARD BOTTOM
LOCKNUTFIG. 2B
BOLTS AND LOCKNUTS (See Fig. 2C)
IMPORTANT: ON TRACTORS WITH FUEL TANK
MOWER DECK BAFFLEUNDER THE SEAT, THE DRAWBAR MUST BE REMOVED
FOR INSTALLATION OF MOUNTING BRACKET. TO
FIG. 1REMOVE DRAWBAR, REMOVE TWO HEX BOLTS ON
BOTH SIDES OF DRAWBAR.
Assemble the mounting bracket, lanced tabs towards
REAR MOUNTING BRACKETbottom, using the four smaller inside holes on the
drawbar.2(See Figs. 2A, 2B & 2C)
NOTE: If your tractor drawbar does not have the four correct
NOTE: If your tractor already has four (4) shoulder bolts
holes for mounting the bracket, refer to the PREPARATION
installed on the rear drawbar, simply hang the mounting
section of this manual.bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group "B" and disregard the remaining Step 2Install the four bolts and locknuts as shown and tighten
instructions.securely.
If drawbar was removed from tractor, reassemble to
tractor at this time. Tighten securely.
BOLTS
LOCKNUTS
SHOULDER
BOLTS
DRAWBAR
MOUNTING
BOLTS
(BOTH SIDES)
LANCED TABS
TOWARD BOTTOM
LANCED TABS TOWARD BOTTOM
FIG. 2A
If your tractor does not have four (4) shoulder bolts installedFIG. 2C
on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"COVER SEAL (See Fig. 3)
Only one set of hardware in GROUP "B" will be used to mount3No hardware required
the rear mounting bracket. To determine which set is correct
Align mark on seal with mark at cover opening.
for your tractor, check to see if there are (2) two upper corner
ribs on each side of drawbar. If your tractor has the upperWork seal into opening so cover sits between flanges of
seal.corner ribs, use the (4) four self tapping shoulder bolts. If your
tractor does not have the corner ribs, use the set of (4) four
bolts and locknuts.ALIGNMENT
MARKS
SELF TAPPING SHOULDER BOLTS (See Fig. 2B)
Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
Hang the mounting bracket, lanced tabs towards bottom,
on the bolts.
COVER SEAL
7FIG. 3 |
ACEC
HUSQVARNA
