Common Operations
Setting the ClockTo adjust the clock again
If you have adjusted the clock before, you need to press
Before operating the unit any further, first set the cCLOCK/TIMER until the OCLOCK� is selected.lock built
in this unit.Y Each time you press the button, the clock/timer setting
Y There is a time limit in doing the following steps. If themodes change as follows:
setting is canceled before you finish, start from step 1Clock time CLOCK
again.
ä REC ä TIMER
Y If you want to stop clock setting, press CLOCK/TIMER
once or wait until the time limit of 15 seconds comes.
If there is a power failure
The clock loses the setting and is reset to OAM 12:00.� You need to
1Press CLOCK/TIMER twice.CLOCK/TIMERset the clock again.
The OCLOCK� appears on the display.
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (AUX,
2Press PROGRAM/SET.FM/AM, CD 6, and TAPE 3), the unit turns on (and thePROGRAM/SET
The hour digits start flashing on theunit starts playing the source if it is ready N COMPU PLAY
display.CONTROL).
To listen to the FM/AM broadcasts, press FM/AM. (See
page 11.)
To play back CDs, press CD 6. (See pages 12 � 13.)
To play back tapes,press T APE 3. (See page 14.)
3Press 4 or c to adjustTo select the external equipment as the sour press AUX.ce,
the hour, then press
PROGRAM/SET.AUXFM/AMCDTAPE
After hour digits are set, the
minute digits start flashing on the
display.
To turn on the unit without plapressying,STANDBY PROGRAM/SET
POWER so that the STANDBY lamp goes off.POWER
4Press 4 or c to adjust
the minute, then press
PROGRAM/SET.
To turn off the unit (on standby), pressSTANDBY
POWER again so that the STANDBY lamp
lights up.POWER
PROGRAM/SET
5Press CLOCK/TIMER twice toCLOCK/TIMER
finish the clock setting.
A little power is always consumed even while the unit is on
standby.
To check the clock timeTo switch off the power supply completelyunplug the , AC
Press CLOCK/TIMER while playing any source.power cord from the AC outlet.CLOCK/TIMER
The clock time appears on the display
for a while.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to OAM 12:00� right away, while the tuner preset
stations (see page 11) will be erased in a few days.
� 9 �
EN01-11.MX-J100[J]/3900.1.5, 3:33 PM |