Getting StartedContinued
English
UnpackingConnecting Antennas
After unpacking, check to be sure that you haFM antennave all the
following items.
The number in the parentheses indicates the quantity of the
pieces supplied.FM antenna (supplied)
Y AM (MW/LW) loop antenna (1)FM 75 COAXIAL
Y FM antenna (1)
Y Remote control (1)
Y Batteries (2)
If any is missing, consult your dealer immediately.
Putting the Batteries into the Remote Control
Insert the batteries N UM-4/AAA/IEC R03 N into the1Attach the FM antenna to the FM 75 W
remote control, by matching the polarity (+ and �) on theCOAXIAL terminal.
batteries with the + and � markings on the battery
compartment.2Extend the FM antenna.
When the remote control can no longer operate the unit,
replace both batteries at the same time.3Fasten it up in the position which gives you
the best reception, then fix it on the wall, etc.
1
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
2
UM-4/AAA/IEC R03
Outdoor FM antenna
(not supplied)
-
+
3+
-
FM 75 COAXIAL
Y DO NOT use an old battery together with a new one.
Y DO NOT use different types of batteries together.
Y DO NOT expose batteries to heat or flame.
Y DO NOT leave the batteries in the battery
A 75 W antenna with coaxial type connector (DIN 45325)
compartment when you are not going to use theshould be used.
remote control for an extended period of time.
Otherwise, it will be damaged from battery leakage.
� 6 �
EN01-13.CA-MXJ150R[E]/f600.5.22, 2:25 PM |
ACEC
JVC
