AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results. Do not try to operate your air conditioner in the cooling mode
This section explains proper air conditioner operation.when outside temperature is below 65°F (18°C). The inside
IMPORTANT: evaporator coil will freeze up, and the air conditioner will not
If you turn off the air conditioner, wait at least 3 minutes operate properly.
before turning it back on. This prevents the air conditioner NOTE: In the event of a power failure, your air conditioner will
from blowing a fuse or tripping a circuit breaker.operate at the previous settings when the power is restored.
Starting Your Air Conditioner?Digital Control
Cool?Cools room. You can adjust temperature by
pressing the plus or minus button. You can select fan
speed by pressing FAN SPEED.
Fan Only?Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
Power Saver?Fan runs only when cooling is needed. You
can select the fan speed by pressing FAN SPEED.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
NOTES:
When the air conditioner is off, the Room indicator light is lit
and the display shows the current room temperature.
If the room temperature is below 55oF (13oC), the display will
show 55oF (13oC). If the room temperature is above 99oF
(37oC), the display will show 99oF (37oC). Fan Speed
When the Set indicator light is lit, the display shows the NOTE: The Fan Speed button will operate only when Cool, Fan
temperature control setting. See ?Temperature.?Only or Power Saver mode has been selected.
When the Hour indicator light is lit, the display shows the time 1. Press FAN SPEED until you see the indicator light come on
remaining on the Timer setting. See ?Timer Delay.?for the setting you desire.
2. Choose Turbo, High or Low.
1. Remove clear protective film from control panel and front
panel badge.
2. Press POWER to turn on air conditioner.
Filter Monitor
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool 1. When Filter indicator light is lit or flashing, remove, clean and
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is replace air filter. See ?Cleaning the Air Filter.?
turned on at all other times, it will display the previous 2. Press and hold FILTER for 3 seconds after cleaning and
settings for 3 seconds, and then display the room replacing the air filter. This resets the Filter Monitor.
temperature.
3. Select mode. See ?Mode.?
4. Select fan speed. See ?Fan Speed.?
5. Set temperature. See ?Temperature.?
Mode
1. Press MODE until you see the indicator light come on for the NOTE: After 360 hours of fan operating time, the Filter indicator
setting you desire. light will turn on. It will remain on for 180 hours or until you press
2. Choose Auto, Cool, Fan Only or Power Saver.FILTER. After 180 hours, it will flash. It will continue flashing until
you press FILTER.
Auto?Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
15 |
ACEC
WHIRLPOOL
