Power Supply Cord
INSTALLATION INSTRUCTIONS
NOTE: Your unit?s device may differ from the one shown.
A
Unpack the Air Conditioner
B
WARNING
TESTRESET
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
A.Test buttonFailure to do so can result in back or other injury.
B.Reset button
Remove packaging materials
This room air conditioner is equipped with a power supply cord
Remove and properly dispose of packaging materials.
required by UL. This power supply cord contains state-of-the-art
Remove tape and glue residue from surfaces before turning
electronics that sense leakage current. If the cord is crushed, the
on the air conditioner. Rub a small amount of liquid dish soap
electronics detect leakage current and power will be
over the adhesive with your fingers. Wipe with warm water
disconnected in a fraction of a second.
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
WARNINGfluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Handle air conditioner gently.
1. Locate provided bag of pan-head screws.
2. Place the top channel on top of the air conditioner, lining up
the holes in top channel with the holes on top of air
conditioner.
Electrical Shock Hazard
3. Using 3 - #10 x 3D?" pan-head screws, attach top channel to
Plug into a grounded 3 prong outlet.air conditioner.
Do not remove ground prong.
BAB
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET.
3. Press TEST (listen for click; Reset button will trip and pop
out).
4. Press and release RESET (listen for click; Reset button will
A.Top channel
latch and remain in). The power supply cord is ready for
B.#10 x 3D?" pan-head screw
operation.
NOTES:
The Reset button must be pushed in for proper operation.
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
Do not use the power supply cord as an off/on switch. The
power supply cord is designed as a protective device.
A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
5 |
ACEC
WHIRLPOOL
