Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and Your washer can be set to drain
spin for heavily soiled loads which and spin out water.
need more detergent. (Extra de- l Push Control Knob in.
tergent can require an extra rinse.) l Turn clockwise to the bar just before
l Push Control Knob in. OFF in any cycle. See above
l Turn clockwise to any. on the dial. drawing.
See above drawing. l Pull Control Knob out.
l Pull Control Knob out. l The washer will drain and spin.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For agitatlon and spin speeds in each cycle, see pages 6-9.
For best results, use warm water for
Fbr a pre-wash pre-washing stained laundry. Hot
water can set stains.
l Use recommended amount of
detergent or presoak product.
l Push Control Knob in.
l Turn clockwise to point to the
number in the PRE-WASH Cycle:
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The PRE-WASH Cycle should
*To start prewash with agitation, the always be followed by a Wash
Cycle Control Knob must point to the Cycle. important: See additional
number in the PRE-WASH Cycle. care infonnatfon on page 7 of your
?Laundry Guide!?
l Set the washer and start the next
selected wash cycle.
MAGIC CLEAN@ lint filter
The lint filter in your washer cleans itself. Collected
lint is drained away with the wash and rinse water.
If your washer drains into a tub, remove any lint
collected in the drain or strainer.
10 |
ACEC
WHIRLPOOL
