g
To pour out the coffee, open the lid of
You can also suck up the milk directly
the thermos jug by unscrewing it in an 3
out of the packaging using the flexible
anti-clockwise direction until it audibly
hose (Figure 2/E).
clicks (or until the marker is over the
Important: The packaging must not be
spout). After pouring, close the lid by
allowed to exceed the height of the
turning it in a clockwise direction until
frothing nozzle. The flexible hose must
it is tight in order to keep the rest of
be inserted down into the packaging.
the coffee warm.
Connect the hose to the frothing noz-
When the water has completely run
zle and insert the other end into the
through and you want to add water for
packaging (Figure 12).
more coffee, you should switch off the
appliance and let it cool down for 0 Place an empty cup underneath the
about 5 minutes.frothing nozzle (Figure 12).
Turn the steam selector to the right
(Figure 8/4). This sucks the milk out of
To froth or heat up milk
the container. It is then mixed with
You can make cappuccino, café au lait steam in the frothed milk spout, and at
and cocoa, or even just heat up milk the same time heated and frothed up.
(for example, as a drink with honey The frothed-up milk flows through the
against colds) using the frothed milk milk discharge outlet into the cup.
spout (Figure 2/A, B, C, D).Important: using the knob for regulat-
Close the frothed milk spout as follows ing the froth (Figure 2/A) you can set
(Figure 10):the amount of froth (more or less
0 Insert the knob for regulating the froth added air) and the temperature of the
(Figure 2/A) into the suction piece (Fig-milk to your taste (Figure 13/A, B, C). To
ure 2/B) and press it on firmly. do this turn the knob slowly to the
right or to the left until you achieve
0 Push the suction piece into the con-
the desired result.
nector (Figure 2/D), place the milk dis-
charge outlet (Figure 2/C) onto the Figure 13/A: maximum froth/
connector. warm milk
0 Firmly attach the complete frothed Figure 13/B: no froth
milk spout to the steam nozzle Figure 13/C: less froth/hot milk
(Figure 1/E) until the red seal of the 0 After making the frothed milk turn the
steam nozzle is no longer visible.steam selector to the 0 position.
0 Leave the appliance switched on after 0 You can froth up as much milk as often
the coffee has been made.as you like provided that there is
0 Wait until the temperature indicator enough excess water in the water tank.
(Figure 8/3) lights up, showing that the If necessary, simply add more water.
steam temperature has been reached.0 Caution: For frothing, do not fill the
water tank above the upwards pointing
Caution: During operation the tem-
3valve, because otherwise the water
perature indicator (Figure 8/3) some-
flows into the coffee brewing system.
times goes off. The required steam
temperature is reached within a short Test what tastes better or what you
3
time by turning the steam selector to prefer: first coffee, then adding
the right.frothed milk, or first frothed milk and
0 Fill the receptacle (Figure 1/F), for then filling up with coffee.
instance with cold milk.
0 Close the lid of the receptacle.
0 Connect the receptacle to the frothing
nozzle (Figure 11).
11 |
ACEC
AEG
