38 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
lThe clock has been set. If not, CLOCK MUST BE SET appears.POWERSLEEP
lChannels are programmed.ALT.CH
lThere is a tape in the TV/VCR (make sure the tapeOs record tab3123
is intact and the tape is long enough to record the program).
456o2
lYou have completed the steps on pages 36-37.CHANNEL
789p
Complete each step within 60 seconds of completing the
previous step. If you donOt, you may return to step 1.0+100o
SPEEDMUTEVOLUME
p
o
PLAY
1�REWF.FWD +
Press the VCR PLUS+ button on the remote control. The on-STOP
p
screen display shown below will appear.REC/OTRMEMORYPAUSE/STILLVCR PLUS+
VCR PLUS+ PROGRAMMENUSTATUS/EXITCLEARSMARTSOUND1
PLUS CODE : � � � � � � � �
TO END PRESS EXIT
2
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record (this
number is different for every program, and it can be four to eight
digits long). Finally, press the VCR PLUS+ button.
VCR PLUS+ PROGRAM
PLUS CODE : 60590 � � �
TO SET PRESS VCR +Helpful Hints
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Y If the power fails, programmed timer
recordings will be lost.
Y You cannot set a timer recording if
3the TV/VCR is in Record Defeat
To record the program once, press the Number 1 buttonmode. To set the Record Defeat
to select ONCE. To record the same program every daymode to OFF, see page 40.
from Monday through Friday, press the Number 2 buttonY If CODE ERROR flashes after you
to select DAILY. To record the same program every
enter the PlusCode programming
week on the same day (such as every Saturday), press the
number and press the VCR PLUS+
Number 3 button to select WEEKLY.
button, the number you entered was
incorrect (for example, too short). IfVCR PLUS+ PROGRAM
1 ONCEthis happens, enter the correct num-
2 DAILY (MON - FRI)
3 WEEKLYber.
TO SELECT PRESS NUMBERY CLASH may flash on the screen after
TO END PRESS EXIT
you complete step 2. This means
that the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out. |
ACEC
PHILIPS
