4 Y Advanced OperationsN Voice Reduce function
1 Press the PRESET key.
4.11 Voice Reduce function
2 Select 09 SAMP/R (SAMP_R ) using the dial or
numeric keys.This function lowers the volume of the vocal part of
3 Press the ENTER key.the material being played back when enabled. Note
4 Select On or Off using the dial.that this may work better on some recordings than
others.
5 Press the ENTER key.
1 Press the PRESET key.
However, even if the sampling point recall is set to
off, memorized sample data can still be loaded later: 2 Select 10 VOICE/R (VOICE_R ) using the dial
or numeric keys.
1 Recall the memory (see 4.10.2, ORecalling a 3 Press the ENTER key.
memory�). If sample points have been stored
in the memory, the IN and OUT keys will �ash 4 Select On or Off using the dial.
three times.
5 Press the ENTER key to conŢrm this setting.
2 Pause playback.
3 Press and hold the OUT key for more than tw4.12o Programmed playback
seconds.
Add up to 30 tracks to a program for programmed
The sample data are loaded, and the IN and
OUT keys will light.playback in a series of program steps.
Even when the power is turned off, if you have set a
4.10.6 Clearing memories
programmed playback order set and enabled timer
It is possible to clear all memories togetherplay, programmed playback will start when the unit , or clear
them individually. is turned on, as the program is stored in memory.
To clear individual memories:4.12.1 Setting the program steps
1 Recall the memory.This adds tracks as program steps in a new program.
2M will show on the display.1 Press the PRESET key.
3 Press and hold the MEMORY key J for two 2 Select 11 PROG (PROG ) using the dial or
seconds or longer.numeric keys.
4 The M in the display will go out.3 Press the ENTER key. The program step num-
ber and the track number are shown on the
To clear all memories.display.
1 Press the PRESET key.
4 Use the SKIP keys C to select the track to be
2 Select 24 ALL/CL (ALL_CL) using the dial or
numeric keys.played as the currently-shown program step.
5 Press the ENTER key to conŢrm the entry.
3 Press the ENTER key. The display will show
-SuRE- (-SURE-).6 Repeat 4 and 5 above for as many steps as will
be entered into the program.
4 Press the ENTER key to conŢrm the deletion of
all memories.7 To Ţnish the program entry sequence, press
the PRESET or ENTER key (or any key except
NOTEthe SKIP keys).
If you are clearing all memories and then turning off 4.12.2 Adding tracks to the middle of a
the power, wait a few seconds between pressing the
ENTER key and turning off the power.program
When you have created a program, you can insert
tracks as new program steps part of the way through
the program.
1 Press the PRESET key.
26 TASCAM CD-302 |
ACEC
TEAC
