IMPORTANT SAFETY INSTRUCTIONS
CAUTION:"Note to CATV system installer:
&Read all of these Instructions.This reminder is provided to call the CATV system installer?s attention to
&Save these Instructions for later use.Section 820-40 of the NEC which provides guidelines for proper grounding
&Follow all Warnings and Instructions marked on the audioand, in particular, specifies that the cable ground shall be connected to the
equipment.grounding system of the building, as close to the point of cable entry as
practical.
1) Read Instructions ? All the safety and operating instructions should
be read before the product is operated.Example of Antenna Grounding as per
2) Retain Instructions ? The safety and operating instructions shouldNational Electrical Code, ANSI/NFPA 70
be retained for future reference.
3) Heed Warnings ? All warnings on the product and in the operating
instructions should be adhered to.ANTENNA
LEAD IN
4) Follow Instructions ? All operating and use instructions should beWIRE
followed.
GROUND
5) Cleaning ? Unplug this product from the wall outlet before cleaning.CLAMP
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for clean-
ing.ANTENNADISCHARGE UNIT
6) Attachments ? Do not use attachments not recommended by the(NEC SECTION 810-20)
product manufacturer as they may cause hazards.ELECTRIC
SERVICE
7) Water and Moisture ? Do not use this product near water ? forEQUIPMENTGROUNDING CONDUCTORS
(NEC SECTION 810-21)
example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet
GROUND CLAMPS
basement; or near a swimming pool; and the like.
POWER SERVICE GROUNDING
8) Accessories ? Do not place this product on an unstable cart, stand,ELECTRODE SYSTEM
(NEC ART 250. PART H)
tripod, bracket, or table. The product may fall, causing serious injury to aNEC - NATIONAL ELECTRICAL CODE
child or adult, and serious damage to the product. Use only with a cart,
stand, tripod, bracket, or table recommended by the manufacturer, or sold15) Lightning ? For added protection for this product during a lightning
with the product. Any mounting of the product should follow the manufac-storm, or when it is left unattended and unused for long periods of time,
turer?s instructions, and should use a mounting accessory recommended byunplug it from the wall outlet and disconnect the antenna or cable system.
the manufacturer.This will prevent damage to the product due to lightning and power-line
9) A product and cart combination should be moved with care. Quick stops,surges.
excessive force, and uneven surfaces may cause the product and cart com-16) Power Lines ? An outside antenna system should not be located in
bination to overturn.the vicinity of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from touch-
ing such power lines or circuits as contact with them might be fatal.
17) Overloading ? Do not overload wall outlets, extension cords, or
integral convenience receptacles as this can result in risk of fire or electric
shock.
18) Object and Liquid Entry ? Never push objects of any kind into
this product through openings as they may touch dangerous voltage points
or short-out parts that could result in a fire or electric shock. Never spill
liquid of any kind on the product.
19) Servicing ? Do not attempt to service this product yourself as open-
10) Ventilation ? Slots and openings in the cabinet are provided for ven-
ing or removing covers may expose you to dangerous voltage or other
tilation and to ensure reliable operation of the product and to protect it from
hazards. Refer all servicing to qualified service personnel.
overheating, and these openings must not be blocked or covered. The open-
20) Damage Requiring Service ? Unplug this product from the wall
ings should never be blocked by placing the product on a bed, sofa, rug, or
outlet and refer servicing to qualified service personnel under the following
other similar surface. This product should not be placed in a built-in instal-
conditions:
lation such as a bookcase or rack unless proper ventilation is provided or
a) when the power-supply cord or plug is damaged.
the manufacturer?s instructions have been adhered to.
b) if liquid has been spilled, or objects have fallen into the product.
11) Power Sources ? This product should be operated only from the
c) if the product has been exposed to rain or water.
type of power source indicated on the marking label. If you are not sure of
d) if the product does not operate normally by following the operating
the type of power supply to your home, consult your product dealer or local
instructions. Adjust only those controls that are covered by the operating
power company. For products intended to operate from battery power, or
instructions as an improper adjustment of other controls may result in
other sources, refer to the operating instructions.damage and will often require extensive work by a qualified technician to
12) Grounding or Polarization ? This product may be equipped with a
restore the product to its normal operation.
polarized alternating-current line plug (a plug having one blade wider than
e) if the product has been dropped or damaged in any way.
the other). This plug will fit into the power outlet only one way. This is a
f ) when the product exhibits a distinct change in performance - this
safety feature. If you are unable to insert the plug fully into the outlet, try
indicates a need for service.
reversing the plug. If the plug should still fail to fit, contact your electrician
21) Replacement Parts ? When replacement parts are required, be sure
to replace your obsolete outlet. Do not defeat the safety purpose of the
the service technician has used replacement parts specified by the manufac-
polarized plug.
turer or have the same characteristics as the original part.
13) Power-Cord Protection ? Power-supply cords should be routed so
Unauthorized substitutions may result in fire, electric shock, or other
that they are not likely to be walked on or pinched by items placed upon or
hazards.
against them, paying particular attention to cords at plugs, convenience
22) Safety Check ? Upon completion of any service or repairs to this
receptacles, and the point where they exit from the product.product, ask the service technician to perform safety checks to determine
14) Outdoor Antenna Grounding ? If an outside antenna or cable
that the product is in proper operating condition.
system is connected to the product, be sure the antenna or cable system is
23) Wall or Ceiling Mounting ? The product should be mounted to a
grounded so as to provide some protection against voltage surges and built-
wall or ceiling only as recommended by the manufacturer.
up static charges. Article 810 of the National Electrical Code, ANSI/NFPA
24) Heat ? The product should be situated away from heat sources such
70, provides information with regard to proper grounding of the mast and
as radiators, heat registers, stoves, or other products (including amplifiers)
supporting structure, grounding of the lead-in wire to an antenna discharge
that produce heat.
unit, size of grounding conductors, location of antenna-discharge unit, con-
nection to grounding electrodes, and requirements for the grounding elec-
trode.
TASCAM CD-RW402 Owner?s Manual 3 |
ACEC
TEAC
