Wall MountingRemote Control Unit
You can mount the center unit and/or the left and right speakersThe provided Remote Control Unit allows the unit to be operated
on a wall. from a distance.
When operating the remote control unit, point it towards the
Option: Attatch the supplied adapter brackets.remote sensor on the front panel of the unit.
Precautions
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there< Be aware that the length of the speaker cable is
are any obstacles between the unit and the remote control.approximately 10 feet (3 m). Do not attempt to mount the
speakers too far from the main unit.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control< Drill holes into solid wall support, such as wooden frame or
concrete wall.
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may also< As a convenience, a set of tapered plastic anchors is supplied.
operate incorrectly.If you chose to use these anchors, drill a pilot hole using
either a 1/4" or 6mm drill bit then tap the anchor into the
pilot hole.
Battery InstallationOnly use these anchors if they are appropriate for the
materials onto which the unit is to be mounted. Consult your
local hardware store if you are uncertain.
1< TEAC supplies these brackets as a convenience to the product
owner. Consult your local building codes and exercise all
necessary caution when mounting these brackets. If you are
unsure how to use the supplied brackets, consult with a local
tradesmen or building supply expert.
2
To hook on the wall
1Use the supplied template to determine drilling points.
2Secure the brackets on the wall.3
3Scew the mounting tabs into the brackets.
Note:
Before going on, make connections between the main unit
and the speakers by referring to the next page. 1Remove the battery compartment cover.
4 Hang the main unit and/or the speakers to the mounting
2Put in the lithium battery (CR2032, 3V).tabs.
3Close the cover.
MAIN UNIT ADAPTERSP UNIT ADAPTER
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the battery is exhausted. In this case, replace
the battery with a new one.
Precautions concerning batteries
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
7 |
ACEC
TEAC
