<P=002>
USING EXTERNAL UNITS
nVideo/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1Use a separately available RCA cord to connect the desired
external unit to the VIDEO/AUX jacks.
(red ? right channel, white ? left channel)
l When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
RCA
cord2Press the ON/STAND-BY button to turn the power on.
3Press the VIDEO/AUX button.
4Operate the external unit.
5To record the sound from the external unit, perform steps 2
To the line output jack- 4 of the "Recording from the built-in radio" section on page
13.
Note:
l To prevent hum interference, do not place this unit near a
television receiver.
nHeadphones
l Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
l Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
l When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
RESETTING THE MICROCOMPUTER
Reset the microcomputer under the following conditions:
X-BASS/
l To erase all of the stored memory contents (clock and timer
DEMOsettings, and tuner and CD presets).
l If the display is not correct.
l If the operation is not correct.
POWER
ON/ 1Press the ON/STAND-BY button to enter the stand-by mode.
STAND-BY
2While pressing down the 0 / R button and the X-BASS/DEMO
button, hold down the ON/STAND-BY button for at least 1
second.
l "CLEAR AL" will appear.
Caution:
l The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
TRANSPORTING THE UNIT
Before you move this product to a new location, proceed
OPEN/
as follows:
CLOSE
POWER 1Press the ON/STAND-BY button to turn the power on.
ON/
STAND-BY2Press the CD button.
3Press the OPEN/CLOSE button to open the disc tray.
CD
l Remove all CDs inserted in the unit.
4Press the OPEN/CLOSE button to close the disc tray.
l Make sure that "NO DISC" is displayed.
5Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power cord from the AC outlet.
15
CD-BA150(SEC) TINSE0279AWZZ |
ACEC
SHARP
