$%$CPPL 1BHF 5VFTEBZ
4FQUFNCFS
1.
Troubleshooting
If you have any trouble using your CDC-3.4, check the following table for possible causes and remedies. If you still
can�t resolve the issue yourself, please contact your Integra/Onkyo dealer.
TroublePossible CauseRemedy
Properly connect the power cord to the CDC-3.4�s
No power.The power cord is not connected properly.AC INLET and connect the other end to a suitable
wall outlet (page 14).
There are no batteries in the remote controller. Install new batteries (page 10).
The batteries are �at.Replace with new batteries (page 10).
Check the batteries and correct as necessary
The batteries are installed incorrectly.
(page 10).
You�re not pointing the remote controller at the Point the remote controller at the CDC-3.4�s
CDC-3.4�s remote sensor.remote sensor (page 10).
The remote controller does Use the remote controller closer to the CDC-3.4
not work.You�re too far away from the CDC-3.4.(page 10). The remote controller has a range of
approximately 5 meters (16 ft.).
Make sure that the CDC-3.4 is not subjected to
A strong light source is interfering with the
direct sunshine or inverter-type �uorescent lights.
CDC-3.4�s remote sensor.
Relocate if necessary.
If the CDC-3.4 is installed in a cabinet with col-
Open the doors, or use a cabinet without colored
ored glass doors, the remote controller may not
glass.
work reliably when the doors are closed.
Load the disc with the label-side facing up
The disc is upside down.
(page 14).
The disc is dirty.Remove the disc and clean it (page 27).
Cannot play a CD.Remove your discs and leave the CDC-3.4 turned
Condensation has formed inside the CDC-3.4.on for several hours until the condensation has
evaporated.
The CD-R/RW disc is nonstandard.See �Disc Notes� on page 26.
The CDC-3.4 is not connected properly.Check all connections and correct as necessary.
There is no sound.The wrong input source is selected on your Check your amp�s input source setting. Refer to
amp.your amp�s manual.
The CDC-3.4 is subject to vibration.Install the CDC-3.4 somewhere free of vibration.
CD playback skips.The disc is dirty.Remove the disc and clean it (page 27).
The disc is very scratched.Buy a new disc.
No disc is loaded.Load a disc (page 14).
Cannot enter track num-
The track number entered doesn�t exist on the
bers for memory playback.Enter the correct track number (page 18).
disc.
It takes a long time to The disc is dirty.Remove the disc and clean it (page 27).
locate certain tracks.The disc is very scratched.Buy a new disc.
To use you must make an analog audio con-
There�s no RCA/phono analog audio connec-nection (RCA/phono) between the CDC-3.4 and
does not work.tion.your Integra/Onkyo AV receiver, even if they are
connected digitally.
The digital outputs do not The sampling rate of the currently playing MP3 Select a track with a sampling rate of 32 kHz,
work.track is not 32 kHz, 44.1 kHz, or 48 kHz.44.1 kHz, or 48 kHz.
Abnormal Behavior
The CDC-3.4 contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this
should happen, unplug the power cord from the wall outlet, wait at least Ţve seconds, and then plug it back in again.
25 |
ACEC
ONKYO
