pg 09-21/CDC775/17-Eng 2/16/00 9:26 AM Page 21
ADDITIONAL INFORMATIONTROUBLESHOOTING
Technical DataIf a fault occurs, run through the points listed belowY Strong magnetic fields near the CD changer.
before taking your changer for repair.aFind another place for the unit or change
Typical Audio PerformanceEnglish
If the fault remains, try to clear it by switching theconnections.
Frequency range: . . . . . . . . . . . . . . . . . . .20 Hz - 20 kHz
changer off and on again. If this also fails to help,
Amplitude non-linearity: . . . . . . . L 2 dB (1 kHz, -70 dB)consult your dealer.No sound or bad sound on headphones.
Dynamic range: . . . . . . . . . . . . . . . . . . . .>90 dB (1 kHz)Under no circumstances should you repair theY Volume control on remote control is at minimum.
Signal-to-noise ratio: . . . . . . . . . . . . . . . .>95 dB (1 kHz)changer yourself as this will invalidate theaIncrease the volume control level.
Y Level control set to � position.
Channel separation: . . . . . . . . . . . . . . . . .>95 dB (1 kHz)guarantee!
aSet level control.
Channel unbalance . . . . . . . . . . . . . . . . . .L 1 dB (1 kHz)
Total harmonic distortion: . . . . . . . . . . . .0.004% (1 kHz)Playback does not start or interruption ofY Headphones plug is dirty.
Audio output level: . . . . . . . . . . . . .2 Vrms, ? 2 dB, 1 kWplayback.aClean plug.
Impedance PHONES socket (6.5 mm): . . . . . .30 � 600WY The current CD has been loaded upside down.Volume is too low.
aReload the CD, label side up.
. . . . . . . . . . . . . . . . . . . . . . . . . (4.5V e.m.f. from 120W)Y Sound level has been adjusted too low with the
Y No CDs inserted.
Digital coaxial output . . . . . . . . . . . . .75W acc. IEC 958�VOLUME + keys on the remote control.
aInsert the CDs, label side up.
aAdjust sound level.
Y The current CD is badly scratched or dirty.
Power supply
aClean the CD with a soft, lint-free cloth.Remote control does not function.
Mains voltage and frequency: . . . . . . . . . . . . . . . . . . . .Y Moisture condensation on the lens.Y Batteries are empty.
. . . . . . . . .see the type plate on the rear of the changeraLeave the CD changer in a warm environment untilaReplace the batteries.
Power consumption: . . . . . . . . . . . . . . . . . . . . . . .<12 Wthe moisture evaporates.
Safety requirements: . . . . . . . . . . . . . . . . . .UL and CSARemote control commands are not properly
Sound skips (at the same part).received.
CabinetY The current CD is dirty.Y The distance between remote control and CD
aClean the CD with a soft, lint-free cloth.changer is larger than 10 metres.
Material/finish: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . .metal and polystyrene with decorative trimThe current CD skips tracks.aReduce the distance between remote control and CD
changer.
Dimensions (w x h x d): . . . . . . . . . .435 x 119 x 380 mmY The CD is damaged or dirty.
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.4 kgaReplace or clean the CD.OdISC NOt FINALISEdO is displayed.
Y The CD-RW (or CD-R) is not properly recorded for the
Playback does not start from the first track (of the
use on a standard CD player.
current CD).
Subject to modificationaRead the instruction booklet of your CD-Rewriteable
Y PRG (program) or SHUFFLE activated.(or CD-Recordable) recorder on how to finalise a
aSwitch off SHUFFLE or clear program.
recording.
No sound or bad sound.Y The CD is badly scratched or dirty.
Y Loose or wrong connections.aReplace or clean the CD.
aCheck connections.
21 |
ACEC
PHILIPS
