THEFT PROTECTIONMuting the sound
(Retractable Front Panel)1Press PWR/MUTE briefly.
When your car?s ignition switch is turned off, the frontMUTE indicator flashes.
panel will be retracted automatically as if there were noTo restore volume, briefly press PWR/MUTE again.
car audio in the console.
When the ignition switch is set to ACC or ON position,Adjusting sound
the front panel will appear automatically.
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
BASIC OPERATION,frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/rear), H-BASS (high bass)*, and DSSA
AUDIO AND CLOCK(Drivers Sound Stage Adjustment)**
ADJUSTMENT* You can reinforce the bass sound.
** You can adjust sound stage and tone balance to best
serve a particular seat in the car.
1Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode?s indicator appears.
2Press + or - to increase or decrease the level for the
selected mode (except for H-BASS and DSSA).
In H-BASS mode, press + or - to select 1 (low),
2 (medium), 3 (high), or OFF.
In DSSA mode, press + or - to select L (for the front
left seat), R (for the front right seat), or OFF.
Turning the unit on/off
Note
? You can turn the unit on by pressing any button on the? Adjust the level or select an item within 5 seconds, or
front panel except z. The unit also turns on when youthe selected mode will return to previous state.ENGLISH
press z and insert a CD.? When DSSA is activated, you cannot adjust BAL, FAD,
? Press and hold PWR/MUTE until the unit turns off.BASS, and TRE.
NoteAligning the source levels
Most operations described in this manual require the
unit to be turned on before starting the operation,(Source Level Adjuster)
unless explicitly stated otherwise.Volume may vary each time you change the source
mode. In this case, you can align each source mode?s
volume to almost the same level.
Changing the source mode
1Press FUNCTION repeatedly to select the desired
1Press FUNCTION.mode.
Pressing FUNCTION cycles through source2Press DISP while pressing SEL.
modes in the following order:?LEVEL 0? appears in the display.
3Press + or - to adjust the level.
Note
* ?CD? does not appear in the display when there is noAdjust the level within 5 seconds, or this function will be
CD in the unit.canceled.
**CD Changer Play mode (available when an optional
CD Changer is connected)Restoring the factory settings
Adjusting the volume1Turn off the unit.
2Press and hold DISP until ?LEVEL --? appears in the
1Press + or -.display.
VOL (volume) indication appears.
Note
You can restore the factory settings only for VOL,
BASS, TRE, BAL, FAD, H-BASS, and DSSA as well as
aligned source volume levels.
ENGLISH ENGLISH 22 |
ACEC
AIWA
