Setting the clockCD-ES9
5Press the or button to adjust the hour and then
press the MEMORY/SET button.
3
Press the or button once to advance the time by 1
hour. Hold it down to advance continuously.
6Press the or button to adjust the minutes and
then press the MEMORY/SET button.
In this example, the clock is set for the 12-hour (AM 12:00) display.
Press the or button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
1Press the ON/STAND-BY button to turn the power on.
To confirm the time display:
[When the unit is in the stand-by mode]2Press the CLOCK/TIMER button.
Press the CLOCK/TIMER button.3Within 10 seconds, press the or button to se-
The time display will appear for about 10 seconds.
lect "CLOCK", and press the MEMORY/SET button.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the or button to display the time.
The time display will appear for about 10 seconds.
Basic Operation
4Press the or button to select 12-hour or 24-Note:
The "CLOCK" will appear or time will flash to confirm the time dis-
play when the AC power supply is restored after a power failure orhour display and then press the MEMORY/SET button.
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not
"AM 12:00"The 12-hour display will appear.appear in step 3, step 4 (for selecting the 12-hour or 24-hour dis-
play) will be skipped.
(AM 12:00 - PM 11:59)
To change the 12-hour or 24-hour display:
"AM 0:00"The 12-hour display will appear.
1 Clear all the programmed contents. [Refer to "Clearing all the
(AM 0:00 - PM 11:59)memory (reset)" on page 33 for details.]
"0:00"The 24-hour display will appear.2 Perform "Setting the clock" from step 1.
(0:00 - 23:59)Note:
The clock can also be set with the remote control.
15
04/1/19CD-ES9(U)2.fmTINSEA055AWZZ |
ACEC
SHARP
