SHARP CDPC671H Repair Manual

CD-PC671H/651H
OPERATION MANUAL

To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets).If the display is not correct.If the operation is not correct.Press the ON/STAND-BY button to enter the stand-by mode.Whilst pressing down the button and the button, hold down the ON/STAND-BY button for at least 1 second.The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets.Remote control
Replace the batteries if the operating distance is reduced or if the operation becomes erratic.Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth.Exposing the sensor on the main unit to strong light may in- terfere with operation. Change the lighting or the direction of the unit.Keep the remote control away from moisture, excessive heat, shock, and vibrations.
Reset the microcomputer under the following conditions: lll1 2Caution: lnNotes concerning use: llll
15
2
15
0.2 m - 6 m (8" - 20')
1,2
RESETTING THE MICROCOMPUTER
The 24-hour display will appear. The 12-hour display will appear. The 12-hour display will appear.
??
?
Press the ON/STAND-BY button to enter the stand-by mode.Press the CLOCK button.Within 5 seconds, press the MEMORY/SET button.Press the TUNING/TIME ( or ) button to select the time display mode."0:00" (0:00 - 23:59) "AM 0:00" (AM 0:00 - PM 11:59) "AM 12:00" (AM 12:00 - PM 11:59)Note that this can only be set when the unit is first installed or it has been reset (see page 29).Press the MEMORY/SET button.Press the TUNING/TIME ( or ) button to adjust the hour.Press the TUNING/TIME ( or ) button once to advance the time by 1 hour. Hold it down to advance continuously.When the 12-hour display is selected, "AM" will change auto- matically to "PM".Press the MEMORY/SET button.Press the TUNING/TIME ( or ) button to adjust the minutes.Press the TUNING/TIME ( or ) button once to advance the time by 1 minute. Hold it down to change the time in 5 minute intervals.The hour setting will not advance even if minutes advance from "59" to "00".Press the MEMORY/SET button.The clock starts operating from "0" seconds. (Seconds are not displayed.)The time display will appear for about 5 seconds.The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow the procedure below to change the clock time.Press the CLOCK button.Within 5 seconds, press the MEMORY/SET button.Perform steps 6 - 9 above.Perform steps 1 - 2 in the section "RESETTING THE MICRO- COMPUTER", on page 29.Perform steps 1 - 9 above.
1234l56ll78ll9lTo see the time display:Press the CLOCK button. lNote: lTo change the clock time:?­?To change the time display mode:?­
TUNING/ TIME ( )
In this example, the clock is set for the 24-hour (0:00) system.0:00AM 0:00AM 12:00
23456789
SETTING THE CLOCK (Main unit operation)CLOCKON/ STAND-BYMEMORY/ SET
� 7 �